Routing

Hi, I am have asr 1004 "asr1000rp1-adventerprisek9.03.03.01.S.151-2.S1.bin" Today I have Ipsec VPN which works on wan interface, i need to add one more ipsec vpn. Can i use two ipsec (crypto msp) on the same interface ? current configuration: cryp...

Hi All, I am going to upgrade the IOS of 7200 from 12.4 to 15.1(4)M10. As a process I need to upgrade the kboot image as well. The required Kboot is of 10Mb however my existing bootflash has only 9 Mb. So just wanted to check whether will I be able t...

WS-C2960X-48LPD-L Catalyst2960-X48 Gig EPoE

I have a /28 network provided by my ISP.  Internally, we have a phone system and two data networks that I'd like to distribute our public IPs to.  Unfortunately, I see that it's not as simple as assigning an individual public IP to each hardware inte...

Hello all, Quick question.  I have a Cisco 1921 running 15.3.  I have 5 static routes setup to route over the IPSec tunnel interface.  If the router reboots, the Tunnel comes up with no issues.  If I do a show IP route, the static routes are not the...

Hi. I need help to port forwarding on cisco 881. The local address of my PBX is 192.168.203.10 and I have a white extarnal ip address X.X.X.X. So with the local users no problems. but i have a user out of my office which i need toconnect to my PBX. I...

Hello: I created a network in my home where the Cisco 1841 router is connected to the Comcast router.  The 2 workstations are getting  IP addresses from a DHCP pool created on the Cisco router which is using NAT.  The subnet from this pool of address...

I implemented VTI first time between two Cisco router.But problem is that it keeps flapping without any obvious reason, when its down, i can ping Public IP of both ends. but Private IP of tunnel dont get ping (since its in down state)any idea how to ...

               Hello, this should be something basic, but I can't figure out how to get around this issue.  I have a 2921 router with 1 etherswitch module installed. I haven't done it before and was trying to change the baud rate to 115200 for instal...

We have a shared office space in University. We would like to have a backup connectivity for internet and primary MPLS. Our demarc is located at ground floor and the shared space is located on 5th floor. We have cat3 cable terminated on the 4th floor...

Hello, I came across an interesting VLSM question the other day, and I was wondering if anybody had any tricks to solving it. I know you can solve it by drawing out the different variables, but is there a quicker way? Here is the question, as well a...

Dears , Current i connect the firewall directly to ISP by this Digram : Outside interface : point to point between router and ISP MPLS  Inside interface : assign it a Public IP  Default route : outside 0.0.0.0 0.0.0.0 MPLS point to point  This cen...