Routing

I'm looking for the OID that would give me all fabric utilization percentages (show platform hardware capacity fabric) for the C6800-*P10G cards.  For older cards (like X6704 and X6708) I'm using cc6kxbarStatisticsInUtil (1.3.6.1.4.1.9.9.217.1.3.1.1....

Hello all, Assume that one site have two gateways. And my question is how to identify which gateway is currently forwarding and receiving the packets ? Regards, Abhijith

Good morning, all! I'm trying to map out expected behaviours on a couple of BGP configurations.   There are two ISP's feeding into my datacenter.  We're advertising and receiving default routes only and the negotiated keepalive for each is 30 seconds...

Hi  We have limited the throughput of router using below command. platform hardware throughput limit  Is there any way to check how much it is getting utilized against the limit set with the router Thanks, Yogesh

Doing a Lab and now I am on ACLs.  What would be the standard and/or extended ACLs for my router with only 2 interfaces, gi0/1 (the side of my internal network) and gi0/0 (the side that connects to the internet)?  I'm looking to secure my network the...

Hello all, I must configure HSRP like below. Below diagram is a part of mine that I plan to deal with. As you know, upper network diagram is weird because we originally connect SW1 - SW2 each other. However, I mustn't connect SW1-SW2. In this circ...

Hi Team, Currently I am working in a medium level company,we have couple of branches over India.Yesterday I configured one of the 1841 series router through console by taking remote access of Cochin(One of the city in India).Every one is connected th...

Hello all I am struggling with this question: suppose you have 2 iBGP routers in the same AS domain, and you configure "aggregate-address xxxxx summary-only" on only one, will it only advertise the summary to its iBGP neighbor also ? Will the specifi...

Hi I am adding some static route in Nexus7000. Please see the picture attached. After I enter "ip route 1.1.1.0/24 vlan 10 2.2.2.2 ?" I get the output as the attached picture shows. Based on the output, I should type name and then name of the next ho...

Hi All, I'm getting the following error log from my RV110W router fast few months, and the Data of the log entry showing as 2010 but the Router is working fine. Can some one help on this issue?  2010-01-01 00:00:23 RV110W kern.err pflash: found no ...