Routing

Hi all,I am managing a Hub and Spoke network with more than 1000 Spokes. The initial MTU of the tunnel interface we've configured is 1400 (on both hubs and Spokes).I am facing now some issue with customers that have a WAN line with a lower MTU: ping ...

i have a AIR-LAP1142N-A-K9 and have a VPN configured but one of the IP addreses changed how can i input the new correct IP address

I have a 10M ethernet link and am up/up on the link, I can ping the neighbor, but am not seeing BGP established on my end ("Active").  Telco is telling me they are sending routes, but are not receiving routes from me.  My question is in a state of "A...

I´m doing a design for presale, where  I will  need a router what support PAT for 500 or a little more of users, it  not need any more features only static routing and dhcp pool for 500 users, can you help me for know what router recommend?

When viewing the output of this command, how much traffic would be classed as a "lot"Over a VPN tunnel between two of our sites and over a period of a few minutes I was seeing the the following bursts between a PC and Exchange Server over the VPN. Sr...

Hi ,We have issue BGP neighborship With Service provider flapping 2-3 times in day. We have two BGP VPN VRF family configured and on same WAN ckt. BGP neighbor in one VRF family is stable more than 6 months but BGP neighbor in another VRF family is f...

Have this 6504, which after some power issues on the site, it boots in rommon mode, all the time and comes with crashinfo.First, I was looking on the output I got, and then search on the error messages from that output, and that indicated on faulty s...

It looks like PfR can do this but I have only found information about this feature which will start using ISP2 once ISP1 reaches 75% usage. But this is not load balancing.Can we accomplish load balancing utilizing a single router with dual ISPs using...

Hello All,I have a brand new asr 901 with IOS asr901-universalk9-mz.152-2.SNH1.binI tried to upgrade license to AdvancedMetro and I received following output:SW-ME-LAG-901#license install flash:CAT1649U0W3_201408010022219070.licInstalling licenses fr...

        After upgrading our RV220W router to 1.04.17 firmware I am getting the following error message consistently.PLATFORM [System] /pfrm2.0/bin/bwLimitConfig /tmp/system.db 18 dot11STA 10 failed. status=-1What does it mean?  How do I get rid of it...