Routing

We recently upgraded our bandwidth from 30Mbps to 100Mbps from our ISP. Ever since then we have been having problems with bandwidth to our two branch sites. I had to struggle to get everything connecting at 100 Full Duplex, forcing some to take. We p...

Below is the config I have setup in my lab and it works great with allowing me to influence which path inbound traffic takes to my network.  The only question I have is this.....   I am prepending the AS with "1 1 1"  which are just random numbers i ...

Hello,I'm trying to create CoPP on ASR 1002-X. I've created several base classess for different kinds of traffic I'm expecting to see.This works fine, OSPF, HSRP, ARP, BFD packets are going to their respective classes. But there are still some packet...

3 switches Catalyst 3750  POE-48  in a stack. After a power cut one of the switches are show no devices are connected.The switch has power. Green Solid Syst and stat. However no devices are connected. No LED's lit on any of the ports.Have done the ba...

I am using CSR1000V router as an experiment however it comes with 3 Gbit interfaces with the ova format I am using. I am wondering if there is any way to add serial interface DCE/DTE to the router? Thanks, 

I am unable to set up the device - I get the following error:CCP encountered an error while executing the command :yourname#term len 0yourname#conf tEnter configuration commands, one per line.  End with CNTL/Z.yourname(config)#username ccpuser privil...

All  We have a VPN users connecting to our ASA 5520 they come in on the following IP address 192.168.212.0/24 they then can access the internet via the company LAN and then out to Proof point all good. we have a new application that can only permits ...

I have my 1941 router connected to my Comcast Modem on G0/0.  I have a 3560 connected to G0/1.  The router is handling my DHCP duties. I have a HAI Omnipro ii (Security/Home Automation) that I would like to access remotely.  It has an IP address of 1...

Hello everyone, I have a WBPN that is configured correctly - as far as I know - however, when I make a call and I"m on the call it goes silent and then all of the computers that are linked to my TRENDnet router all get kicked off, including my comput...

Between two datacenter sites we have a WAN connection provided by a local Telco and routing between sites is using BGP.We also have a layer 2 fibre end to end connection between the datacenters for diversity, although this fibre link is not part of t...

Hi I've got problem trying to connect the CISCO-887VDSL/ADSL OVER POTS ROUTER to internet. Only got the LAN part working.I'm trying to setup PPPoE with dynamic IPFollowed CISCO's documentations but the commands used were not recognized by the router....