Routing

Hey Guys,I need some help with E1 counters. The company I work for has a cisco CUCM with two gateways, and each gateway with 4 E1 connections. I know cisco did a great job at documenting what each counter error represent, but I am knew so I dont have...

We have a Cisco RV042G Gigabit Dual WAN VPN Router.We need to use an external DNS server provided by Gamma that has an IP address with the last value being .255   (i.e 88.*.*.255)       However, the Router comes back with an error message :"DNS Serve...

HII have the following scenario. We are running OSPF on our LAN Core's and have Radio links as our Primary path back to the HQ, and MPLS Links (diginet) as backups on all our sites. We then have a Regional Data Centre (called RDC) inside the MPLS tha...

Hi everyone,I have a ASR 1006.ASR-R#show versionCisco IOS Software, IOS-XE Software (PPC_LINUX_IOSD-ADVENTERPRISEK9-M), Version 15.3(2)S2, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2013 by Cisco Syste...

Hi,I have a E1 link in production and I install a new router 3925 with VWIC3-4MFT-T1/E1 module, I put the same configuration than the old router 3825 but since this change the E1 link has problems, there is high latency and drop packets.I attach the...

Hi I have configured two EFP into one Bridgedomain with Bridge DomainID 44.Now I want to have a L3 interface in the BD, as I know from other platforms this is done by configuring SVI 44 which is associated with BDI 44, so far so good, unfortunately i...

                   Hello everyone,I bought a H3C MSR 30 40 router to replace a netgear home router. I know its not a Cisco router, but I would guess setup is somewhat similar? If anyone here has knowledge of H3C MSR routers here and knows how to do a...

I want to rate limit a specific public ip address on a sub-interface (VLAN 100) to 500k of it so that the group of people in that VLAN 100 do not suck up all bandwidth with cloudsync.  So, couple questions. Question 1:CloudSync has one public IP addr...

Hi Team, We have Cisco 7206vxr Router installed at the Customer site and facing issue as described below and our Observation during the Network gets unreachable.1. Remote VSATs are up and next IP (Fa0/1) also reachable from DC-1 Router.snap shot atta...

Hi there,If a 897VAW router has NPE IOS and AIS License how can I change this to Encryption?Does it require downloading an IOS with encryption only?Thanks,Amar

Hello All,I have this topology below:When I use the VPN router to ping any IP Address on the WAN side, it works since I have a default routeIslamVPN#sh run | i ip routeip route 0.0.0.0 0.0.0.0 192.168.1.1on the LAN Router, I can only ping the 192.168...

Hi,If anyone can help explain how the CPU usage on ISRG2 routers works I would greatly appreciate it. Normally when I see a CPU usage spike you can use the show proc cpu sorted command to see what process is using that CPU and then troubleshoot from ...

Hi,Need some advice on the following. Have 2 data centers currently active/standby and am looking to advertise the same /24 prefixes from both locations in case a DC is lost. Currently not an option to use something like GTM in an active/active type ...