Routing

Hi All,i bought the wrong interface cards vwic3-1mft-e1/t1 and it is not working when my vendor trying to set it up.Need some advise from you guys, if it is possible to configure the e1/t1 card to run on this g703 unframe link? understand the con wil...

Hello.I have configured LDP graceful restart (GR) )on two routers (the same configuration):mpls ldp graceful-restart timers neighbor-liveness 100mpls ldp graceful-restart timers max-recovery 110mpls ldp graceful-restartNext I set TCP filter on both s...

Hello.I have two LSRs connecting via single link. I want to check LDP-OSPF synchronization. But it doesnt work. My config for side A:A#sh run | s ospf router ospf 1 mpls ldp sync mpls ldp autoconfig area 0 log-adjacency-changes network 1.1.1.0 0.0.0....

which IOS supports SSH version 3 in Cisco routers and switches ?           

Hello Need help I have a BOM with a router C2921-VSEC/K9 in my config I put this modulo ISM-VPN-29 can anyone tell me is this is necessary to do VPN IPSEC?can I do that VPN IPsec without that? thanks

Hi all,today my sw upgrade procedure failed on a ME3600 Series switch.**************************Interrupt within 5 seconds to abort boot process.Loading "flash:/update/me360x-universalk9-mz.151-2.EY/me360x-universalk9-mz.151-2.EY.bin"...@@@@@@@@@@@<....

Hello,My isp provides me with an adsl connection, details as below.PPPoAVCMUXVPI 0VCI 100specific un/passI need to bridge my cisco867 such that the public ip is passed on to the device plugged into the lan port of the cisco867.Can anyone provide me w...

I'm updating an ASR 1002 that was recently decommissioned before sending it to a new location and, after reading the docs a bit more thoroughly, a small question popped up.The device is based on ASR1002-RP1, with ASR1000-ESP10 and ASR1002-SIP10.  I'v...

Hi guys, hoping someone will be ale to help. I have 3 2610's that are having the exact same problem when on boot up the above end message shows and just sits there. I have managed to get into ROMMON mode and updated the IOS to a more recent version b...

Until you have single WAN, the problem doesn't exist; but when you have to configure multiple WANs, born the issue.In specific I'm speaking about the CISCO888-EA-K9.System image file is "flash:c800-universalk9-mz.SPA.153-2.T.bin"Normally you can add ...

Wanted to find out everyones opinion on this website:http://www.internetpulse.com/How good or bad it is.  Basically we are having issues where most of our Verizon DSL or FIoS customers are complaining that they are seeing latency accessing us and the...

I have a 2801 router with two vpn tunnels going to two other sites. They share a T-1 (1.544mbps) link. When I perform a "sh int tu21", it shows 100k which I noticed today when I was on my management station.1)  Why is this?2) Should I set the bw manu...