Routing

Hi All,i Am having a problem at one of my site, for every 2 hrs GBP is reestablished. i found thelog in router:Dec 13 07:41:55.507 CST: %FW-6-DROP_PKT: Dropping tcp session 10.158.186.6:4466129.33.160.116:443  due to  RST inside current window with i...

hi,i would like have a configuration advise with eigrpI have a 3750 at a remote site and Nexus at the core and currently both sites are connected through a fiber running eigrp.I would like to add another layer 2 service connecting between the remote ...

Hi,I am using the cisco linksys E1200 WiFi router.when ever I connect my laptop to WiFi, its show Limited connectivity/Yellow Caution sign when connected. I try to reconfigre it & also in factory default mode it show same.Please help me.Regards,Milan...

Hi Guys,I'd like to configure LDAP support on our several Cisco MDS 9216 and 9222I in our lab,in order for users on our Active Directory domain tpo login to our SAN Switches with their domain credetials.I haven't found any step by step guide. Could y...

Hi,We have CISCO2811 model with VWIC2-2MFT-T1/E1 module working good over the E1 line.Since it's getting hard to find new model of CISCO2811 we decided to connect new branches with CISCO2911/K9 model (according to migration doc) My question is can we...

Hi,I have a Router 2801What conf should i make to allow access for a specific hosts from the lan just to a few websites.!no ip dhcp use vrf connectedip dhcp excluded-address 192.168.1.1 192.168.1.63ip dhcp excluded-address 192.168.1.192 192.168.1.254...

Hi Everybody, I have on  7200 series router with NPE-G1 module which is facing high CPU utilization. I have not found any particular process causing this high CPU utilization as it is caused due to interrupts. I have already enabled fast switching by...

I want to link ASA 5505 to two ISP's for backup purpsoses.I can see this configuation example herehttp://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806e880b.shtmlQuestion - does the ASA 5505 do load balacning...

Hi guys,     Maybe someone can shed some insight on this....ip nat inside source static tcp 192.168.167.5 10001 interface GigabitEthernet0/1 10001This works, but, not what I want as it's sending this port to ONE ip.  It shows up in the 'show ip nat t...

Hii have the below topologyCORE1---------ASA-------R1-----InternetR2-WAN-------Branch1core-1 and R2-WAN and Branch 1 are undere eigrp 3, also i have a default route from core 1 point to asa, i have the subnet 10.10.0.0 on my lan, i have seted up a l2...

i am having issues with frequent bgp flaps on the Cisco 7200 series router from past 1 week. I have raised a ticket with ISP but couldn't get any resolution from them as the flap is for about 2min.When ever we see BGP flap, we are not able to ping th...

router bgp 65457no synchronizationbgp log-neighbor-changesnetwork 10.64.16.0 mask 255.255.240.0network 10.66.0.236 mask 255.255.255.252network 172.31.240.0 mask 255.255.255.0aggregate-address 10.66.0.0 255.255.240.0 summary-onlyredistribute staticnei...