Routing

Yes this is very old, but I hope someone can help me out here.  Lost a disk that had CWM 10.5, Informix and the Informix raw partitions(don't ask me about the build, I inherited it) on it.  New disk, recreated everything, restored CWM and Informix fr...

Hello Team,Any idea why my OC3 interface is showing increasing output drops its starts happening as soon traffic exceed 60Mbps   ( FYI my traffic never exceeded 75Mbps MAX, and circuit is 150Mbps from carrier , full OC3)Any thoughts how i can fix th...

Hi , I'm trying to do lab with  BGP  route selection using weight, my purpose is to apply weight in edge router  for specified incoming prefix (41.10.10.0/24) with neighbor 66.10.10.1 , the config of edge in attached document I the result of sh ip b...

I'm checking some config with backup analogue line configured as DDRSh dialer shows dial string and status idle.How can I check when this dialer trigger from idel to active?There is no other interface looking external, but there is HSRP configred bet...

if using RED/WRED for congestion what else would cause output drops. i ask because i have a higher number of total output drops than I do with RED drops. Basically why im I not seeing the other drops, supposedly i have 719 drops but only 421 by RED, ...

Hi Expertswhen y trace a BGP Route form the looking glass what the below mean?Last Update1d0h2m39s ago (1 path installed)thanksjamil

HelloI have some questions about Cisco 837. I couln't ding a good datasheet for that.1- Does Cisco 837 4 port ethernet switch is a managed switch? 2- How many VLANs does it support? 3- Does it supports EIGRP and OSPF anf BGP?4- Does it supports SVI?A...

Hi ExpertsWhat are the reasons of the Prefix flapping in global BGP Tablethanksjamil

I have read through these forums, and have yet to find an answer to my scenario.I have 2 VLAN's set up, but my Cisco WLC cannot reach the internet.VLAN 10 Tagged is Cisco WLC 4402-50 Series assigning DHCP of 172.16.0.x / 255.255.252.0 (Public Wifi)VL...

Dears,I have two ISP need to connect them on my router.The Router that I have is 2811 where it contains two Fa ports only, so I put an access switch between the two ISPs and the Fa0/0 then configured the Interface Fa0/0 with two IPs ISP1 and ISP2 as ...

I have a Cisco 876 router running 12.4.(15)T5, configured as DHCP client.  This works nicely.A Cisco 886 router, running 15.1 software also works with the DHCP client.  This also works but has the following strange beheaviour:In the running-config an...