Routing

Hi All,Just want to say a big thank you to all the Net Pros that devote their time & resources to help others.I was recently on this forum when I configured VPN between two of our sites. I got the VPN up and running and all the resources working with...

I already have a route-map in place allowing traffic from 192.168.101.0/24 to use dual ISP, tracked using SLA.I want a host behind to have a specific public IP, so I can connect too either public IP if one ISP fails.  I was thinking something like th...

Would anyone please let me know what is below log for ME3400,Oct 20 18:33:35.040 EST: %SSH-4-SSH2_UNEXPECTED_MSG: Unexpected message type has arrived. Terminating the connectionOct 20 18:38:55.823 EST: %SSH-4-SSH2_UNEXPECTED_MSG: Unexpected message t...

hi all,I have dought to clarify with you. I have a vlan interface and R1 learend that route from the OSPF. Then I did the area summurization in R1 router 10.74.0.0/19 ( area 0 10.74.0.0 255.255.224.0). Then in R3 I accepted only few routes using a Ro...

Dears,We have a problem with processor 4 in slot 1 where SAMI card is located. Let me briefly explain whats happening.We are trying to connect to the internet using a 3G modem. In order to be able to connect to the internet user should pass A11 authe...

Hi dears.i installed new WS-X6516A on 6500 series switch. the module front panel led is off and the status is power down.how i troubshouting this module? is this physical problem? or  must I  write any command to active the module? please help me.tha...

Hi all,How to upgrade IOS XR from 4.1.2 to 4.2.0?Is their any specific requirement for same?What precaution i have to take while upgrading process?

ip http serverip http secure-serverno ip nat service sip udp port 5060ip nat inside source list 1 interface FastEthernet0/0/0 overloadip nat inside source list 101 interface FastEthernet0/0/0 overloadip nat inside source list 103 interface FastEthern...

I have several IPsec vpn tunnels to the main site.  The remote locations are using 871 routers and the main site is using an ASA 5510.  I am using the tunnels for both voice and data.  I would like to implement Rip or some type of dynamic routing bet...

Hi,I have 2 6500 Core switches in VSS configuration.Redundant VSL links are configured between them in below fashion.Te1/5/4 of switch1 is connected to Te2/5/4 of switch2 in Portchannel1 which is up.Te1/5/5 of switch1 is connected to Te2/5/5 of switc...

Is it acceptable to use peer groups solely as an organization contruct even if there is only one peer in the group?  It certainly makes the BGP config cleaner to follow, but are there down-sides to this?