Routing

Hi,Cannot ping serial interfaces. Cable type is T1 crossover.cARD type - WIC T1 DSU/CSU - version 1==========================================Router 1 - 2611XMinterface Serial0/0 no ip address no fair-queue service-module t1 clock source internal!inte...

Dear allWould like your assistance plz in verifying why below simple PBR is not implemented in H/W knowing the Copp is not configuredNPE-1#sh ver | i image System image file is "bootdisk:c7600rsp72043-advipservices-mz.122-33.SRE0a" NPE-1#sh run int G...

Hi,I need some help in BGP routing. is it possible to publish the same network in two sites which are connected using MPLS cloud? I have 10 locations, all are connected using MPLS. I have a dedicted link between 2 sites (site A and B), so that if sit...

Hi Guys ,I am a VPN admin and i was going through some static routes configured on the internel interface of the ssl vpn box.I saw the following entries:Internal Port  Status    Destination      Network/IP Netmask                    Gateway          ...

i want below switch data sheetModular core switch with 24 nos of 10/100/100Tx ports and 4 nos of 1000SFP combo-ports

Event Date: November 17, 2011Time: 9:30 am to 10:30 am PST. For local times check: http://www.easytz.com/?t=2011-11-17-17-30&d=60&l=5972-463d-2651-3f21-4bda-233-3eb-1c64-5803-2b84-42e8-1008-4aafWhere: On our Facebook page at http://www.facebook.com/C...

i want below switch datasheetDistribution switch with 20/24 nos of 100/1000SFP ports and 4 nos 10/100/1000TX combo ports

Hi All,We have servers in HO/ domain, at the partner company they are in workgroup, we established L2L VPN between 2 sites, they can ping our server e.g sqlmanager by IP address and name , they can even nslookup as well, BUT they cannot load it on an...

Hi all,What would be the best way to configure NAT on Cisco IOS in such a way that when a packet arrives on the outside of my router, it is redirected to an internal host but changing the source IP? Does anyone have a similar IOS configuration?Thanks...

Hey All,I was wondering if someone could help remind me whether or not BGP and / or MPLS LDP peerings have to occur using a / 32 address.  If so, why?Thanks in advance!David

Hi All!    So.. I'm stumped. We got a 1921 router that works fine. We ordered Verizon Businss One Static IP ADSL. It came with a Westell Modem that we configured in bridge mode. When we do a test by assigning a static IP to our laptop then hook it up...

Hi everyone, I have an 891 router currently configured as a central hub for several LAN to LAN VPN's and that is all working as it should. This morning I used the configuration professional wizard to setup EasyVPN so that a few remote users can gain ...