Routing

Hello,I am looking for some roadmap information on VPLS and OTV, can someone address this?Is VPLS/A-VPLS on the roadmap for the ASR1000?  Also when is OTV support expected on the ASR 1000s and the 6500s.  Trying to figure out what our options are for...

hoe can i enable the WICK card then i will be able to configure these Interfaces?plesae sene me the full commands---Posted by WebUser Faheem Awan

Hi All,We have one site which has 2Mbps E1 through ISP. Recently, it's keeping bouncing. Sometimes it was stable for couple of hours and suddenly into a intermittent status. Called ISP and they said it's grounding issue causing that. We asked electri...

HiWe are moving towards Virtualization with HP enclosure. The enclosure got 2 Cisco Catalyst Blade Switch 3020 and by default Ethernet ports are interconnected for High Availability We configured a trunk port from our distribution switch 3750 to each...

Hi Team,We are facing issue of high CPU utilisation for Cisco 2811 Router installed in Customer premises and using for Internet connectivity.Find attached here show tech-support for this Router and suggest us for next step,Regards,Ashutosh

I have a BT SWSS NTE 52D with a flashing red light on the 2M/X.21 indicator and out put on the E1 controller as:E1 0/0/0 is down.  Applique type is Channelized E1 - balanced  Description: BT ISDN-30 IMBT Pilot [number]  Transmitter is sending remote ...

HI AllI have  excuted the command ip virtual-reassembly max-reassemblies 64 under the interface.still we are facing the issue

Hello,can i use BFD fast detection to activate EEM on ASR 1004 platform ?, i f i  can, does anyone have good doc explaing how to do it ?the idea is that i have L2TPv3 tunnel which i need to have a H.A tunnel in a second router. since BPDU wont pass o...

I have many HWIC-3G-HSPA cards as backup connections and I need to keep them up for monitoring purposes. Being a backup connection they get little interesting traffic for them to spring into life but they are the source interface for a tunnel interfa...

Hi all,Shall I know why eBGP AD is 20 which is less than any dynamic routing protocols?As far as I know, one reason is suboptimal paths and not sure about any thing related with routing loops.Regards...-Ashok.

Task: Implement QoS. Traffic from YourBOGUSBackbone needs to be limited to 2000Kbit with burst 10K on R3 fa0/0.R1-----R3(fa0/0)----------YourBOGUSBackboneMy question:Is the implementation below using "service-policy input" correct?Someone made a poin...

i received this syslog message on my cisco 3845 router Nov 11 13:36:06.265 UTC: ASSERTION FAILED: file "../les/if_ng_dslsar_tx.c", line 385does any one has an idea what is that message mean.Thanks

Hello,Is it possible to configure the RV220W to forward ports without connecting to the SSL VPN?If so, how?Thanks,Dave

have a new setup for a branch that will be connected in our mpls in w/c hq and dr is the 2 manin hub, both hq and dr sites also has regional wan connection for regional connections to dc.we are running single area ospf in hq and dr witth connection t...