Routing

Can anyone help, I'm looking for documentation of the following commandcontroller VDSL <n> modem xxxxxxSpecifically the 887VA variant. There are a couple of commands explained in the readme of the latest firmware but I'd like to understand what confi...

Hi,Please see the attached diagram.We have SAP servers at DC from which invoice prints will to to Agri printers 172.16.11.0/24 (P1 P2 P3).The router 10.30.1.2 is connected to Agri.We have static route from 10.30.1.1 to Agri. (ip route 172.16.11.0 255...

Greetings,I am attempting to configure a Cisco 2901 router using IOS 15 to  properly perform NAT/PAT translation between LAN and the internet  connection. I've configured DHCP pool for the local interface (GigabitEthernet0/1), which  works properly. ...

Hi,I have 2 switches.One is Hp procurve 2650 semi manageable  & other cisco 3560 layer3 switch.In both switches 3 vlans are configured. Hp switch trunk port (gigabit port)is connected to L3 switch trunk port(gigabit).The default gateway is L3 switch....

Hi Cisco expert guys,My router is Cisco 1811W. I have got connected by ISP's(Ziggo of Netherlands) given Ubee cable modem router and it directly connected with Cisco router through ethernet cable in FastEthernet port (1). I am trying to get dynamic I...

Guys can someone plz tell me th eprefix-list config what is le32 meansip-prefix list 10 permit 192.168.1.0/24 le 32so if i write ip-prefix list 10 permit 192.168.1.0/24what is the differencewhat abt ge conceptThanks guys

I have  a cisco cat 3560  and the present IOS is 12.2(46)SE  and  i  want to upgarade the IOS to 12.2(58)se1.As  there is  only 8mb of frees space  i cant straightly  copy the new IOS on the switch.please guide me the convinent way to Upgrade IOS.Tha...

Dear,I have designed and implemented my organisation with fully redundant/load sharing setup via BGP, but facing small issue like looping and my other remote site which are on same (MPLS cloud) BGP-AS are sending the traffic to only new Backup router...

I need some assistancein configuring radius authentication for my client VPN and management authentication for the my ASA.  I am not quite sure how to do that as I am already authenticating my clients via Radius.Anyone know how to separate the two on...

To anyoneWe are switching over to a new ISP and the settings from the old ISP Statstic IP,DNS, is on the Cisco 891 router.Question can I just edit the settings that are already on the Cisco 891 router.I clicked on the CCP exress Went to the Task Inte...

I have just installed a new 887 in a branch office. Two GRE tunnels are configured back to our two head office routers. Only one of the tunnels is able to send EIGRP hellos successfully and hence, one tunnel adjacency is flapping after the RTO is max...

Dear all,please as par diagram we need implement QOS for voice & video

Hi,On my country, international bandwidth still expensive. I want to split local and international bandwidth and limit inbound and outbound bandwidth for each ip like this:IP 10.100.10.11 can use 100Mbps local bandwidth, 1Mbps international bandwidth...