Routing

I have this issue below which the RXload is alway high above 200/255 but I did a sh ip accounting, Not sure how i can prove it to the apps side that these are the traffic load. Would need more advise on expert whether is it the configuration or reall...

I was referred to this website:https://tools.cisco.com/SWIFT/Licensing/LicenseAdminServlet/checkStatusto lookup the license for my new 881 router. On this webpage, it first requests three fields of information:- Product ID- Serial Number- Device Cre...

We have several of these that we took out and replaced with 1130'sThey have always been connected over POE.  We are wanting to use them in different locations.When we went to configure them, we reset them, plugged them in with a power brick and then ...

Dear Cisco Prof  My Scenario :I have 3 Cisco Routers as following :G.SHDSL Router : Cisco 3845 withISDN and Branch Router : Cisco 2811How My Network works :Branch Router has two type of connection ( First one : G.SHDSL link work as Main link and the ...

Hi folks, Imagine I will deploy an Ethernet circuit for a 10 typical office user site.Imagine that is a centralized environment.Compressed VoIP calls (~34K/per user).Have you seen any estimate on what is the bandwidth you would estimate for each user...

Reposted from ServerFault.com, and ASK THE EXPERTS - QoS with Cisco expert Sarala Akella, where it didn't get an answer, except to confirm the omission of set-dscp-transmit from the 3560 manual.I’m the chairman of the wiring committee for a hundred-u...

Hello Experts,Please review the attachmet.  Our corporate office has decided to deploy BGP on our new DWDM ring and OSPF as the IGP.I am familiar with OSPF, but have minimal knowledge of BGP. Corporate engineers sent us the BGP configurations that we...

Hi,I have a problem configuring Cisco 881. The network is very simple - on one side router from internet provider, on other side ~50 computers behind NAT.The link to service provider is properly configured (I can test it form router tools, ping etc.,...

We have 2 T1's bundled in Mu1. The Mu1 interface is showing input, frame, and overrun errors, however the serial interfaces do not show any errors. I know there is a bug out there there that is close, however this is supposed to be fixed in our versi...

We are facing issue while configuring dynamic IPSEC with TED feature on 7609 (VPN SPA card). We are using c7600rsp72043-adventerprisek9-mz.151-2.S.bin IOS. Feature navigator suggest that this IOS support TED feature but as soon as I enable discover c...

Hi,Recently I was studying EIGRP on a lab scenario and noticed a strange thing.I connected three routers in a chainR1---------R3--------R2The connection between R1 and R3 is direcly connected ethernet with a cross cable while the connection between R...

Hi,I have been gone through cisco Doc ID: 91672 "WOL support Across the VLANs configuration example".have a confusion.the L3 switch/router has already configured "ip helper-address <DHCP server>" on vlan interface. WoL server ip is 10.x.x.xmy questio...

Hello,I have a problem with IPSEC. My branch office router has two terminations 1.ethernet based termination TO INTERNET terminated to GIG(0/0).2.3G connection to internet. I have configured an IPSEC Tunnel to the head office.. I want the tunnel to ...

Hello,In IOS 12.x router set the "candidate default" status to the network (set by "ip default-network" command) regardless of the mask. In IOS 15.x this only happen if this network will be classfull network. This is intended effect or bug?Regards,Da...