Routing

Hi,I have enabled the command on modem line 'session-timeout 2' which disconnects the line if it is idle for 2 minutes. Is there any command i can run to see how many modem calls get timedout due to session time expires.show caller timeout (only show...

Hello , I am getting the below mentioned error logs in my  Cisco 7206VXR in the POS interfacesMar 31 12:16:19.783: %ENTITY_ALARM-6-INFO: ASSERT CRITICAL PO2/0 Threshold Cross Alarm - B3 Mar 31 12:16:29.787: %ENTITY_ALARM-6-INFO: CLEAR CRITICAL PO2/0 ...

Imagine I have the following functional configuration below.Then I am exploring a backup circuit via Satellite in case primary MPLS circuit goes down the hill. I get to the backup circuit via the ip route on the bottom - OK.Note that 98.65.252.60/30 ...

Dear Experts,We have stucked with a redistribution scenerio of BGP-EIGRP & EIGRP-BGP.Connectivity is like, We have a core network of 4 EIGRP routers (R1-R2-R3-R4)  and from R2 & R3 1-1 BGP configured Rts are connected respectively.redistribution comm...

Hello everybody,Here's my setup:R1 (Hub) has two serial connections to FR switch, R2 and R3 each have one serial connection to FR switch.Now my question is how can go about assigning the DLCIs? When I try to apply the following command frame-relay ro...

How do I bias an etherchannel?I have one group of etherchannels(2links).1st link = 100Mbit/s2nd link = 20Mbit/sHow do I make all the traffic go over the faster first link and then only over the 2nd link if the 1st link fails? Is it possible to make...

Hello,Im currently a student and i cant figure this one out. I have attached a packet tracer file for you to review.I need to make a vpn connection between pc0 and pc1, they are obviously in a different subnet. I have configured RIP on all the router...

DEar all,Can you suggest the configuration for for router LAN intweface for the  topology attached :Case: 1 - HSRP configurationCase - 2 VRRP cofnngiruationTopology: Regards

This is my first posting so I might not be in the correct area.  I am going to need to connect two cisco routers over a T1/E1 dedicated circuit.  Right now I'm Nortel routers going through channel bank controllers using CAS(Channel Associated Signali...

Assuming I have the MQC in place and I applied it in the interface.Interface s1/0 service-policy output QOSclass-map HTTP  match protocol httpclass-map VOICE  match dscp efpolicy-map QOS  class VOICE   priority percent 18  class HTTP   bandwidth perc...

Hi Folks,In OER, the master controller uses passive monitoring to measure the delay, packet loss, reachability and throughput.  For those of you who had implemented OER, is there any tool have these information replicated on a separate medium other t...