Routing

Hi,We received this question from our CSC Facebook communityhttp://www.facebook.com/CiscoSupportCommunityArshia Enayati I need help.....how I can set authentication on an interface on router ospf (area 0) not whole interfaces on area...

Hi,One of my customer is having problem with sending and receiving email from external email server. It used to work but started having problem recently and the router configuration was not changed. The email hosting company and the WAN service provi...

Today we have 7 offices on our MPLS. We are started to add secondary internet connections for failover. The initial idea was drop the internet connection in and then ship out a lower end router to be a VPN End point and it would be a manual failover....

Hi,I have an asa 5510 along with two different Data lines, one primary the other is for fail over.  Can i connect both lines to the asa and have it automatically switch over to the backup line if primary is down?

Hi,I am getting following errors on the router :000040: Nov 10 15:37:28.000: %FW-4-ALERT_ON: getting aggressive, count (4/3000) current 1-min rate: 501000041: Nov 10 15:37:52.901: %FW-4-ALERT_OFF: calming down, count (0/2500) current 1-min rate: 342H...

Good day, i have two 7200 vrx router series with two E3 interfaces, and im just using one on each router. The question is how many branch offices can i connect to these equipment. For example: i need to connect like a hundred offices to each router ...

hi i´m looking for the signed document "declaration of conformity" of an WS-C2940-8TF-S eg http://www.cisco.com/en/US/prod/video/ps11070/ps11102/MP2240xx_CE__DoC.pdfI find only general information .... XX Statement - Declaration of ... without signat...

Hello,I would like to know if I can configure my UC520 to support Dual WAN for failover or Bonded DSL.To add a second WAN do I need to add any upgrade module to UC520?Thank You,Sean

Hi all,I'm a bit lost with an issue on ISDN interfaces...I'm using ISDN for satellite needs and I'm facing a strange issue on one vessel. Let me explain the case :From the vessel to the HQ ISDN concentrator : everything is OK (here is the debug isdn ...

So,without going into it too deeply ...All I need to know is, if I create a GRE tunnel from my 4507 to the 6500k will the AD no longer been seen as 170 for external and be seen as AD 90.I'm assuming it will but if anyone here can poke holes in my the...

I have the following config::!interface Vlan 10 ip address 10.45.61.129 255.255.255.240 ip virtual-reassembly in ip tcp adjust-mss 1380 ip policy route-map 10-Net!route-map 10-Net permit 10 match ip address 107 set ip next-hop 192.168.112.126 192.168...

Hey all, we've done a lot of back and forth between our Internet provider and the destination host network support team and have not been able to find a solution. By now it's pretty clear the "ghost" is downstream somewhere on the Internet but I just...