Routing

Hi,I have some strange output that the routes I learned from OSPF is indeed in the OSPF Routing table but it is not in the Database table.For example,show ip route ospf -- the output will show me the routesshow ip ospf database -- those routes are no...

please i need to configure out of band management on cisco 2811 routers to manage alcatel routers.i would appreciate help on how to go about achieving this with relevant documents.thanks for anticpate response

This is kind of a WAN issue and kind of a VPN issue, so hopefully I'm posting this in the right area. I have two sites:Site A:  Cisco ASA 5510 with 6Mb connection to the InternetSite B:  Cisco 2801 with T1 connection to the internetSite A and B are c...

please can someone help urgently on why i could not make a connection to an alcatel router.find below details of my logs.1.could be a cable problem2. is my config incompletethanks for anticipated helpCurrent configuration : 4580 bytes!version 12.4ser...

I have a setup of 3 routers with 2 configured for HSRP and third is just collecting RIP advertisments from earlier two. What I see is third router gets RIP advertisements only from Secondary HSRP router and not from the primary. My RIP config is pret...

we have 2 ISP and 2 public pool from different ISp if one goes down applications are not accesible from outside .i want total redundancycan any body suggest solution for that

Hi,This router was initially configured thru SDM software and later modified by CCP. They created the following ACLs:access-list 1 remark INSIDE_IF=Vlan1access-list 1 remark CCP_ACL Category=2access-list 1 permit anyaccess-list 2 remark Auto generate...

I need to calculate the reliability of interface.Please help me how to do.Thank you !!!Anup

Hello Dears,What one can suggest a percentage value for traffic storm-control for Broadcast and Unicast traffic on Catalyst 3550 Access switches (END USERS) Ports.Thanks,

Hi,This questions came from our CSC Facebook community.http://www.facebook.com/CiscoSupportCommunityArshad Ameen hi all i need u r helpi wan to disable telnet connection to my router from all other subnets otherthan the subnet of my router...i have a...

We have a 7206VXR NPE-G1 running 12.3(4r)T3. WCCP shows the following:Global WCCP information:    Router information:        Router Identifier:                   x.x.220.57        Protocol Version:                    2.0    Service Identifier: 80    ...