Routing

Hi,I am planning to extend my bgp routes of Private Network Cloud to core switch which is cisco 4510 switch.Before that just wanted to make sure the 4510 switch which is acting as core is capable of handling present 4300 bgp routes of private colud &...

Hello,I am upgrading new IOS image on a stack switches of 9 (3750G-48TS) for enabling faeture of SSH as it is currently lacking SSH login feature. I came across through cisco documentation that I can upgrade the new IOS image on all 9 switchs of a st...

I have a serial interface card (s0/1/0.16) which we curretly use for our T-1 connection.  I have second T-1 line coming and was wondering if I could use the "controller T1 0/2/0' interface for the same purpose as the serial interface?  (see config be...

HiI really need help on making a configuration in a router 2600, I have 2 ISP (one Cantv and Movistar) one of them will give me a 2mbps of bandw with a static IP and the other will give me an DHCP IP address With 1.5 mbps, and I have to make a load...

We want to connect as follows:Internet <--> ISP PPPoE DSL Modem <--> Cisco 881 (DMVPN) <--> Cisco 871 (IPSec VPN) <--> LAN1 (Private)                                                                 <--> LAN2 (private)We have 1 DSL internet connection...

Hey everybody,Got a small home networking problem. I have a DSL line from at&t a modem from them 2Wire 1701GH which servs as a wireless router. I am trying to connect a Linksys WRTU54G-TM router to it because that one has a jack for a phone line so I...

I am having a problem with a BGP connection in that my local policy appears to be denying almost all prefixes per the followiing excerpt from "sh ip bgp neighbor":                                   Outbound    Inbound  Local Policy Denied Prefixes:  ...

Be most grateful if someone could check this out.I have a (nuther make ) wireless router that I wish to attach to the 877 via one of the FA ports877 has 12.4 Enterprise IOS /  256 RAM / 40 flash( I would love to use an 877W -- but Cisco have not upgr...

Hi guysI got a 2 devices CPE_BE and DC_UK. From CPE_BE I cannot perform any ISDN outband call (international and national) however from the DC_UK I can call the ISDN line of CPE_BE, I can see the authentication etc etc, call is setup properly.I think...