Routing

HiI need a bit of assistance setting up a WAN link between two sites.Our ISP has provided us with a WAN Extension link between the two sites. On Site A's end we have their equipment installed with two VLANS. VLAN 183 is our new direct link to the int...

HiI have a problem which i hope someone could shed some light on.Currently I have 1 external IP address a  Webserver in the DMZ and a Exchange\OWA server in the LAN the router is a cisco 881.We have a port rediorect rule to send all 443 traffic to th...

Hi,Trying to adjust admin distance of external routes injected in OSPF domain from eigrp :router ospf  10redistribute eigrp 11 subnetsdistance 200 0.0.0.0 255.255.255.255 eig-to-ospfip access-list standard eig-to-ospfpermit ip 10.1.1.0 0.0.0.255permi...

Hi, This document here says that if you use any flaour of dfc3a/b on a VSS system, then VSS will be disabled -http://www.cisco.com/en/US/products/hw/switches/ps708/products_qanda_item09186a00809a7673.shtml#qa6At the bottom of this document it says th...

HI NetPros, I am trying to move my single point of failure up from my 3750 to my pix 515e.  Currently, the 3750 has a default route to the pix inside interface.  I have a second 3750 that I have confgured with HSRP.  I would like to add it in the mix...

Hi,I have a 4507RE and just copied over a new IOS (cat4500-ipbase-mz.122-31.SGA11.bin). Since the older image is currently loaded, i need to reboot the switch so that the new image can be loaded. What command do I use to instruct the switch to use th...

Hello,I have this 2610 router and I'm trying to flash a new IOS.  The router was given to us so we do not have the passwords.I get to rommon and do "confreg 0x2101" then "reset" to reboot the router.The problem is that it loads the installed IOS norm...

Here is an over view of our network design:We use Metero Ethernet.           ISP            |        2800 Series Router            |         ASA            |       3750G (Central Office) Internal IP Routing            |       3750G (Multiple Remote s...

HiI have a router which is connected to two different ISPs. From my host network, the traffic is passed to firewall where global PAT is configured and than this traffic is forwarded to Router for further forwarding.Now my requirement is that I want a...