Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

Resolved! SNMP OID

Dear Experts,For a very long time I face difficulties to get SNMP OID and Object Name. I know that I can use "SNMP Object Navigator" in cisco site. But to use thisI should know either OID value or Object Name.For Instance, one of my requirement was l...

Hi, I have initiated Traceroute from my Router & am confused with Tree times msec in the reply with each next hops. Please guide me why three times Msec is there for each IP and what is its mean?Router# traceroute 208.11.11.1051 200.22.22.111 60 ms...

Hi,what is the best way to measure the bandwidth, packet losses, jitter and delay between two systems over IP network?ThnksAnas

justanas1 by Level 1
  • 1049 Views
  • 6 replies
  • 0 Helpful votes

I need opions on best options to control bandwidthwe have an OC3 ATM with a 20Mb PVC connecting to Qwest MPLS cloud in our main data center. All endpoints connect into this MPLS cloud and all have full t1 access. We discovered today when someone wit...

sschulak by Level 1
  • 1266 Views
  • 8 replies
  • 0 Helpful votes

hi guys,we have a problem with the router 2801,a normal configuration of the pppoe adsl,ter term length 0Router#sh run Building configuration...Current configuration : 1865 bytes!version 12.4service timestamps debug datetime msecservice timestamps...

jvalin__s by Level 1
  • 1211 Views
  • 14 replies
  • 0 Helpful votes

Resolved! Sup 720 failover

Hi,We have installed 2 SUP 720 into 6509 switch and would like to change default failover time to reduce delay.What is the config we need on sup 720?Regards.

I have two routers each connected to a different ISP. Router A acts as primary and Router B acts as secondary. Router A and Router B are not directly connected but are connected to boarders switches A and B that are interconnected. I want to use the ...

mmorfejr by Level 1
  • 403 Views
  • 3 replies
  • 0 Helpful votes

Hello,We had a hell of a time deploying our Clean Access Server in as a Virtual Gateway in a central deployment. We were deploying the device for VPN users to do assessment of thier machines. So far all is working alright. We had to change the origin...

Pete89 by Level 2
  • 498 Views
  • 9 replies
  • 0 Helpful votes

Per the Cisco documentation,"The BGP synchronization rule states that if an AS provides transit service to another AS, BGP should not advertise a route until all of the routers within the AS have learned about the route via an IGP."In the above rule,...