Routing

Dear all,please take a look at the following output:**************************************router#show loggingSep 16 14:10:45: RT: SET_LAST_RDB for NET.NET.NET.NET/32 OLD rdb: via WAN1.WAN1.WAN1.WAN1 NEW rdb: via WAN2.WAN2.WAN2.WAN2Sep 16 14:10:45: ...

Hi,Area 0 is connectd to area 1 by two routers R1 and R2 area border routers. We need some routes to be sent to back bone area by router R1 and remaining all to be sent to backbone area by R2. so that when data from back bone , for some destination...

According to the output:c2800#show control-plane host open-portsActive internet connections (servers and established)Prot Local Address Foreign Address Service State tcp *:23 *:0 ...

Hello All,Can anyone explain meaning of the below error message:brse517(config-router-af)#redistribute static route-map SET-COMMUNITY-STATIC% "SET-COMMUNITY-STATIC" used as redistribute static into bgp route-map, set extcommunity rt not supported

Can someone help with a bonded T1 (2xT1) configuration? Our ISP installed the lines then told us we're on our own. Now i have a line that's been activated and just sitting there. I just need the basic configuration in order to connect to the internet...

I want to route all traffic from 10.20.1.0/24 (Vlan1) to the next hop address 10.0.0.1 (see diagram).When I try to put the cmd "ip policy route-map pbr_fa0/1" on Vlan1, the cmd is accepted, but does not show up in the configuration. Why? When I test ...

On a 3825 with 4 hwic-4t1/e1 cards all is working well until we add a 4th or 4th and 5th line to our MPLS multilink bundle. We have 5 circuits, and any combination of 3 runs reliably. When we add another circuit the connection destablized resulting i...

Hi guys I have a client who is applying for 2 internet leased line circuits from 2 different ISP's.I have 2 - cisco 2800 router for the internet connectivity.I have a L3 switch in the internal zones of the routers.Both the ISP's have given /30 public...

Hi,I have the following:AS5300 with an E1 PRI line.There are about 1000 devices that call in, make connection, transfer data and disconnect.My customer now wants to implement callback for these devices. So a device calls, gets authenticated, line get...

What is an Interface Virtual-Access1? I recently noticed this interface on a 2800 series router after installing a second T1 circuit and creating a Multilink combining both my T1s. I hadn't noticed this interface before. What is its purpose?

HI,Running into an issue trying to install a GEIP+ card into a 7507 running IOS 12.4(25) Service Provider, with RSP4's. The following error is displayed:{Sep 9 08:45:35.915 CDT: %DBUS-3-SW_NOTRDY: DBUS software not ready for slot 6 after DOWNLOAD, ...

I need to verify this image (c2800nm-adventerprisek9-mz.124-25b.bin)using /md5. I can't seem to find the location for thd MD5 values. Does anyone have the URL? Thanks.

Looking for confirmation I can do this. 1841 has 2 interfaces: FE 0/0 and FE 0/1. 0/0 is WAN w/public IP of 65.183.46.182. LAN is FE 0/1 with 192.168.1.1. Currently have users using browser-based access to IP cameras by http://65.183.46.182:xxxx, whe...