Routing

Hi,Can some please help me figure out why i can't pre classify traffic correctly?Here is what i'm trying to do - I have an ADSL home office router with an IP phone connected to a 3560 switch of interface Fa0/0. If i enable nbar an match traffic on t...

R3: -- HUB RouterR4: -- Cloud R5: -- Spoke Router As discussed in above scenario I am not able to ping from R3 to R5 in GRE Multimode Tunnel. Actually I want to run OSPF over Dynamic Multipoint IPSec VPNs (Using Multipoint GRE NHRP)R3#R3#sh runR3#sh...

Hi.I have the following problem. A Client with a main and a remote site entering to an MPLS network. I have consistent QoS politics and we have voice traffic (precedence 5, priority queue) with not delay variation in the delay when congestion occurs....

Hi,I've a 6524 (ME-C6524GT-8S) with IOS version 12.2(18)ZU2.Today I made 5 times the procedure for password recovery and I've noticed that, after the command "copy startup-config running-config", the L3 interfaces (virtual and physical) and L2 trunk ...

Here is what I am getting with debug.The connection drops in 1 secondCan you please tell where is the wrong password coming from?Apr 10 20:11:54: BR0/0:1 CHAP: O CHALLENGE id 24 len 27 from "kwepdx"*Apr 10 20:11:54: BR0/0:1 CHAP: I CHALLENGE id 83 le...

Hey Guys,I keep getting the below system on one of our wan routers that terminates a vpn tunnel.Aug 19 11:29:13.553 AEST: %VPN_HW-1-PACKET_ERROR: slot: 0 Packet Encryption/Decryption error, Output Authentication error:srcadr=x.x.x.x,dstadr=x.x.x.x,si...

Good day,I have a remote site with a WAE and a data center with a WAE.. Download time is fine but upload time is alot longer.When I upload the file to my file server at the data center after changes are made, should it send the whole file or just the...

Hi,Please how can I monitor or know the amount of packets flowing through the port of a router or switch.Is it possible to see a real time flow statistics.I configured 'ip route cache flow' on the interface of the router and I can use 'show ip cache ...

Hi all....I have two location Mumbai and pune configuring with two link using BGP and other static route.From pune i am using static route for both the link.Pls find the attachment.I test the config,At pune when reliance link goes down, traffic autom...

Hi to all,I have some questions about the topology in the attached file. As you can see I have a ring topology between three buildings, but the routers E and F have only 1 successor (and no feasible successor)to reach respectively the network a and b...

Hi Folks,I need a little help. I have 2 sites that are connected by a metro ethernet using a 3560 & 3750. We experience a congestion, I tried to run ipaccounting on the interface vlan that links the site. I was able to apply it on the 3750G but when ...

Hi,I have to recovery the login and enable password for a Cisco 6524 and Cisco 7604 with Sup32.How can I do?In fact I don't find the recovery procedure for 6524 and for Sup32 on cisco website.thanks for helping meantonio