Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

Start a conversation

no Annex M in dsl operating-mode

i recently purchased an 877 routerconfiguring the ATM0 interface cannot find Annex M there is only A and LC877(config-if)#dsl operating-mode ? adsl2 ITU G.992.3 Annex A and L adsl2+ ITU G.992.5 Annex A ansi-dmt ANSI T1.413 auto auto ...

Resolved! 7613 atm card failure

Hi I have a 7613 router with image "c7600rsp72043-adventerprisek9-mz.122-33.SRD2.bin" but my router cannot enable my SPA-4XOC3-ATM. I am getting this message "SPA-4XOC3-ATM card in subslot 1/0 is being disabled because of an incompatible FPD image ve...

Resolved! ADSL with cisco 871

Hi, our customer has a branch office that should be connected to central place via VPN site-to-site connection.In branch is in use ADSL line via ethernet cable with name and password authentication again ISP network. For connection will be used a cis...

Resolved! Auto QoS Voip on 1841

Hi, Have got one of these router at one of our remote site. With this IOS version can it support Auto Qos VoIP ?Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(1c), RELEASE SOFTWARE (fc1)Let me know

Resolved! Multicasting Fast switching

Hi Experts, ip igmp static-groupDonot Accept But forwards Multicast trafficip igmp join-group Accepts and forwards Multicast traffic I understood the meaning and behaviour of these two commands, But What is confusing me is, WHY FAST SWITCHING IS PRE...

Route tagging

All,Am I correct in my assumption that route tagging is primarily used in redistributing scenarios, and the tags are usually set on the router that's doing the redistributing?Thanks,John

Choice of device? 3750E??

Hi Guys,I am thinking of picking up a 3750E switch since I have a requirement of switch ports and I need to run BGP on it. There will be three EBGP and one iBGP connection running on the device. I need to know what is the routing table size that a 37...

Resolved! Redistribution of EIGRP Classless into OSPF

I'm learning how to redistribute EIGRP into OSPF. I have three routers: eigrp---eigrp/ospf----ospf (see attachment).After configuring eigrp into OSPF, I run #show ip route on the ospf router, the eigrp routes shows up as O, E1 routes. Why can't I pin...

traffic not return in IPSEC tunnel

What are possible reasons that traffic doesn't return in an IPSEC tunnel?I see with sh crypto ipsec sa that packets become encrypted at the sending site and decrypted at the remote site but they doesn't return. :-(1)routing problem at the other side2...

Delete Question

I cannot for the life of me delete the flash:html directory on a cisco 3524 switch.tried rmdir flash:html and keep getting errors. Seems that files in this directory are corrupt and I need to whack it and upload it again. There are over 70 files in h...

dj214 by • Level 1
  • 236 Views
  • 1 replies
  • 0 Helpful votes

HSPA and the 880G Router

I have a puzzling scenario regarding to mobile setups. the setup includes 1 laptop and 3 desktops.Problem. how do I get them to communicate securley VIA VPN when they both need to connect VIA HSPA+. Will the attached doc actually work? Niether of the...

dekuil by • Level 1
  • 235 Views
  • 1 replies
  • 0 Helpful votes

Cisco 1812 Router

I just had a bonded T1 (3Meg) installed. Does the 1812 support this type of connection? Do i need a CSU/DSU between the T1 and the router. Finally, should i be using an RJ45 or RJ48 connector?Thanks

View All
Review Cisco Networking products for a $25 gift card