What is the recommended IOS for 3750 Metro Ethernet to be used for AT&T opt-e-man? Can someone share their experiance please?Thanks,Yo
What is the recommended IOS for 3750 Metro Ethernet to be used for AT&T opt-e-man? Can someone share their experiance please?Thanks,Yo
Hi,in my router there is 64F/256D, In this memory configuration how big routing table can be operate by the Router? How do I know that Memory is getting full to operate full routing table.
Hi , We have recently purchased fortinet devices for all of our branches. We are new for that. Is there any body has worked on fortinet and give me a suggestions. whether the device is suitable to purchase at least. we are struggling at the device?
I am trying to use the Cisco SDM Express Wizard to initially configure a 1812 ISR. During the wizard, at the "Internet (WAN)" page, I am instructed to choose an interface (FE0 and FE1 show up) and click the "Add Connection" button to enter connection...
We experience poor voice quality between IP phones at 2 sites connected by 2M MPLS link. The call statistics show packets lost (RxLost) but no packets discarded. Voice packets are not prioritised in router due to cost issue, but bandwidth utilisation...
HiI understand that the 7613 boot's in order from 1 to the last ios loaded on the disk, my challenge is to change from number 4 to number 1. I have downloaded the ios but it's on number 4 and i have deleted the ios that was on top(number 1) , now I w...
I'm trying to set-up a VPN between two 2600 routers. On router1 the ip address is 192.168.7.1 On router2 192.168.6.3. For testing purposes I have a 1700 router in between them and they are connected with T1 DSU/CSU WIC Cards with crossover t1 cabl...
Dear Friends,1. I have the attached Network Switch setup in our office.i am just new to this place and trying to understand the topology.we have more than 25 vlans in our network and VTP enbaled in it.manually spanning-tree root switch has not been c...
Track interfaceI have a router with two linksleased line as primary link and ADSL VPN as back upIhave a static route for primary and floating satic for adsl vpnmy question is how to remove staic routing when the primay link goes down and back up tak...
Experts,I am in process of troubleshooting a bouncing bgp session. Scenerio : 2 routers running ebgp, connected via a L2 link. Config vise they are directly connected. Problem: BGP bounces occassinally. No errors, drops observed on physical interface...
I have a star network with multiple l2l tunnels. I am trying to give priority to RDP (3389) traffic. The following is my config that I am trying to use: hostname(config)#class-map RDP_Prihostname(config-cmap)#description "This class-map matches all...
Hi there Experts just badly needed a wonderful help for my Home Lab issue as I'm about to give up. Couldn't get the two interfaces pingable. I have got R1 and R2 connected via DCE/DTE cross-over serial cable and have configs for both routers shown be...
I need to set FRTS with a cir of 128k but I need to lower the time interval to the minimum, I think is 150ms, any help plese?
Hello Everyone,We have a Cisco 3825 router. I would like to limit the bandwidth for three IP addresses.60.203.x.1 - LAN (no limit)60.203.x.2 - Web Server (3mb limit)60.203.x.3 - FTP Server (3mb limit)60.203.x.4 - Mail Server (3mb limit)I found the fo...
I need someone to help me with buying a Cisco router and its accessories for my HQ. Am thinking along the line of a 2851. I need to connect in 4 remote sites all through telco lease circuit running 2megs. To start of with 1 of the 4 WAN sites we will...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
04-26-2024 03:04 PM | ||
04-26-2024 01:23 PM | ||
04-26-2024 09:18 AM | ||
04-26-2024 07:58 AM | ||
04-24-2024 03:30 PM |
User | Count |
---|---|
11 | |
9 | |
5 | |
2 | |
2 |