Hi Team,I have a query if i have 2 routes to the same destination one is learned via ospf and another one is via static route with AD-110.Which route will be used for forwarding the data packet and why?
Hi, I just want to check if I have a connection like this R1 -- R2 and it is running eBGP between them. R1 has a route-map outbound to R2 that gives different MED values for a bunch of routes. I shutdown the link on R1 going to R2. The bgp tabl...
hi experts,we have a symmetric internet line that has a rate of 20 meg. i've tested our line using speedtest.com. see attached. could someone enlighten me why the download and upload speeds are different even though it's said to be symmetric? is ther...
Hi, What is the best practice for IP address assignment in DR site. Should it be the same as in Production site or should they be different. And what are the reasons for choosing one. Thanks.
Hi, can someone clarify if for this specific scenario I should use 'always' when doing default origination?Does it make any difference in this case if I use 'originate always' or leave the 'always' out? Attachment is on post below.Please find attache...
Hi there,I have a problem with an 1811w router that has so far eluded all my atempts at solving it. The setup is fairly simple: I have 2 unequal ISP connections that service several computers acrosss a lan, based on access lists (some go through ISP1...
Hi,One of my router configured with 4 loopback addresses and advertised in OSPF.My question is as per my knowledge, if you have more than one loopback addresses configured on router then it select as router ID based on highest ip address. then what d...
GSR--192.168.1.2--pos--192.168.1.1--CRS on CRS ping 192.168.1.2 all ok,whether how large ip packet,display!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! but on GSR ping 192.168.1.1,can not success one packet,i do not set any parame...
Hi, from customer router "CRA", I can't ping ISP router (150.1.0.0 route is not on CRA routing table). Then from service provider routes I can ping CRA just fine. I did a trace from CRA to NAP (service provider router) and traffic dies on upstream, n...
Is it possible to increase the LLQ Priortiy-Queue for VoIP higher than 33% (best practice?) of the total bandwith ?...Bandwith(AR): 1Mbit, 2Mbit, 4Mbit WAN-Link: G.703 or G.SHDSL or 10/100/1000 Ethernet HW: 1841/2821/38xx/7201...any URL on CCO ?any e...
I will be getting business internet service installed in a couple of days and would like to prepare for it.I will have 2 separate lines:1 business WAN with 5 static IPs1 residential WAN, with 1 dynamic IP.Provider supplies CISCO 851 router for the bu...
If I set up a site-to-site VPN using two Cisco routers (one at each site), will users behind either router be able to access the Internet for general usage?I ask because I know that some devices block all other traffic except traffic going over the V...
Dears,i am facing big issue in my remote branch. i have cisco router 2800 series equiped with 3G-HWIC-GSM card. and the 3G connection terminates on 7600 router in HQ site.the issue is as following:when send an e-mail with 3 or 4 attachment files from...
Hello colleagues,Can anyone explain what does "Prefixes Current: Sent Rcvd" in output of "show ip bgp neighbors A.B.C.D" really means?For example:I have an ASBR with several neighbors (uplinks),and for each one I'm announcing about 30 prefixes. All ...
