Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

When peering with another router within the same AS# (iBGP) is it best practice to use the remote serial interface or L0?When peering with a different AS# (eBGP) is it best practice to use L0 addresses and why?Thanks in advance.

Greetings, I have a few sites with Multilink Connections. I have a problem where in when a T1 CKT from a a multilink bundle goes down our monitoring system does not catch the event because connectivity to the site is still works. So the question is, ...

merryllem by Level 1
  • 255 Views
  • 1 replies
  • 0 Helpful votes

After experiencing a sluggish network today, I ran Wireshark on my PC at work for an hour and found 37% of all packets were vrrp advertisements to multicast address 224.0.0.18. Should my PC be getting these multicast packets? Advertisement interval ...

akrauska by Level 1
  • 1313 Views
  • 1 replies
  • 0 Helpful votes

I have a remote site that until recently was connected via L2L tunnel. We now have a DS3 to that site and I'd like to manipulate the cost of OSPF so that it picks the DS3 first and the tunnel second.Can someone point me to a config example or a doc.T...

Hi Team,Is there any possibility we can schedule the backup of network devices with TFTP server (Solarwind Server) at a specific time as we have 300 N/W devices in our n/w and it is quite difficult to take the backup of each n/w device maually.

Scenario:Quad-WAN links between main site and remote site.Two routers on both ends:Main Site:R1 :1 x 1Gig via Metro Ethernet (ISP1)1 x DS3 via MPLS VPN cloud (ISP2)R2 :1 x 1Gig via Metro Ethernet (ISP1)1 x DS3 via MPLS VPN cloud (ISP2)+++++++++++++++...

router rip flash-update-threshold 10 .Please what is the effect of the above command on the periodic routing update.

Forgive me for my ignorance but I don't know enough to even search for relevant posts... I have a Cisco 2811 router. I have a T1 and a Cable Internet connection. I want to be able to configure the router to answer incoming SMTP traffic from either...

LAB Set-upI have 2 CE routers running BGP with a PE router for site AI have the mirror set-up for Site BMy issue is now running BGP between the two PE's and getting the routes to propagate between them.How is this done?CARRIER-A#sh ip bgp sumBGP rout...

Dear Friend, I have a setup in which a cisco 3845 is connected with 15 cisco 2851 routers with leased line.I'm using GRE tunnel with IPSEC for security between router's serial link connectivity.All is working fine. data is encrypt and decr...

siddindia by Level 1
  • 478 Views
  • 6 replies
  • 0 Helpful votes

Resolved! RDP 3389

Friends,---------Site A74.X.X.X /28---------Site B207.X.X.X /30Host 10.104.64.118 <---Client to use RDP---------Scenario:Host 10.104.64.118 from Site B needs to use remote desktop to access a server at Site A using port 3389. Both are Cisco 1841's ....