Routing

Hi, I need help on how to achieve ISP level failover for LAN based outbound and DMZ inbound traffic.Scenario (attached diagram)LAN -> Firewal1 (in HA) -> WAN Routers (1&2) (in HA using HSRP) -> ISP-01 (Using two different Last miles)LAN -> Firewal...

Hi, anyone know what the correct power cable to use for Chile is? I've been told it may be an Italy power cord. Its for a WAE-512-K9. Thanks.

I have a 3640 router that is effectively configured on our network as ISDN dial up for backup in case our Frame Relay network fails.My manager brought me a phone bill from our provider earlier. Last month we found that on some days, this router is d...

Hi All,Having received some great help on this forum, I have successfully installed a WIC1-ADSL card in my 2651XM router and am now thinking of getting a WIC1-SHDSL for it. The version of IOS I have on the router is: Cisco IOS Software, C2600 Softwar...

Hi all , i have one 871 router there wan port is not working ,i have done all basic troubleshot ,reset it , cable change but the port is not getting connected,can port becomes faulty or any other?Thanks

Hi,I've got a message on my 7206 vxr router saying there's a mismatch between my IOS and my kboot (which is indeed the case) and tried to change the kboot version to match the IOS. But I can't delete/change the old one with this new (not enough space...

Hi Experts,I would like to setup something like the below Router connection. PC B PC C | |PC A - Router A - Router B - Router C - Router D - PC DPC - stands for computer.I would like t...

Hi All, Can anyone please tell me how to go about how ONLY a specific routes should be allowed from the BB routers?, i.e. R1 should not accept any routes from BB1 that have an odd number in the first octet.Please help me!!!!!!!

What is the function of these 2 commands on router? ip ssh time-out 60ip ssh authentication-retries 2

Following is the configuration of Switching module in router. interface FastEthernet1/0 switchport access vlan 5 switchport mode trunk ! interface FastEthernet1/1 no switchport ip address 10.1.1.1 255.255.255.0 ! interface FastEthernet1/2 no switchpo...

Dear all,Normally, Vlan 110 is the best route between Multicast server and Multicast client, and so Multicast also follow the best route to run. Therefore, I can see that the Multicast source is from Vlan 110 in VSS. However, If I statically add "ip ...

Is there a soft client to connect into a 500 series router or do I need another 500 series router to connect the the VPN. Looking at the product info it looks like I'd need another router. However this would be crazy for traveling employees.