Routing

Hi : Below is a sample config on rate limitFor your example this could be the configuration ! ! Your access-list defining your internal ! traffic access-list 101 permit ip x.x.x.x y.y.y.y any access-list 102 permit ip a.a.a.a b.b.b.b any . . . access...

HiIs showing in the output of these commands below different types of queueing strategyWhy this happening?Thanks#show interface Serial1/0/4:30…output omitted...Queueing strategy: -->Class-based queueing<--#show queueing interface serial 1/0/4:30Int...

Hope someone can help!We have Verizon FIOS 20/20Mbps service at our facility connected to a 1812 router. We seem to be having a performce issue. Some websites display slowly. Can someone have a look and see what is wrong with my config?ip tcp selecti...

Is there typically something that has to be done to enable a trunk when being done across a metro ethernet link? I have two switches that I set up that trunk fine when connected with a crossover but will not trunk when connected over the metro-e. I c...

Hi, I am using ASA 55200 firewall. My internal subnet is 10.4.0.0.I want to confirm, if both PAT and Static nat is configured, Does Static nat work ?What is the meaning of same IP in Static nat ?Hope, PAT/Static NAT works only for traffic if initiate...

Hello experts,How to configure Tunnel Between two locationsLocationA :Int Gi 0/0 - 10.242.1.1/29Int Gi 0/1 - no ip - will be used for LANLocationB : Int Gi 0/0-10.242.120.1/29int Gi 0/1 - no ip -will be used for LANLocation A and B are connected with...

All,I have the attached diagram that I need to create a DR scenario for. I've tested this in a lab, but I wanted to get your opinions.The 10.10.10.0/24 network is our corporate subnet. If the link between AS1 and AS4 (AT&T) goes down, I want the syst...

Hi, I am facing one strange problem with PPP over FR. I have router R1 & R3 connected over FR. I have configured PPP over FR on Vitual Templete. I am using EIGRP. The problem is EIGRP neighbor is formed, but they are not exchanging the routing table....

i have one 2821 router with latest ios 12.4.25a ,but when i install hwic-1fe the card not detected and card shows continues link .if ios is the problem so pls suggest the specific ios or other solution .

Dear All,We are experiencing packet loss when ping from PE1 to CE2 when the traffic above 7.2Mbps.CE1 - PE1 - PE2 - CE2 Type of point-to-point between PE2 and CE2 is 4x E1 multilink (bandwidth 8192Kbit).Note*** (PE1 to PE2 no packet loss)We do see th...

hi, We have three sites A, B and C and I would like to configure site-to-site VPN for the traffic going from A to C via B with 2800 routers in each site. Is it better/possible to define one tunnel from A to C via B or should two tunnels be defined i....

I have Internet connection to an ISP who assigned PA IP addresses in which some of the IP addresses is used in hosting Microsoft Exchange in house. We wish to add another ISP who will assigned another block of its own PA IP addresses. We wish to use ...

Hello all,Has anyone seen/built a config in which a pair of 6500s in VSS are used at the Internet Edge? I picture the VSS multi-homed to several ISPs using BGP and the FWSMs providing ACL/NAT functionality.Please let me know if you have seen this do...