Routing

Hello,I setup IPv6 anycast (client) (RFC 3068) on my 1812 router. The router is using a pppoe dialer 1 via vlan 10 (FTTB-network that uses VLANs between vdsl-modem and IAD).Here you go with the config:--- cut ---interface FastEthernet2 description WA...

The following configuration is on our WAN routers. The problem is, data traffic stills take up the entire T1 and the voice quality becomes extremely poor when there are file transfers. If I create another policy-map called FILE_XFR and put it under t...

Hi,We have a new ISDN router Cisco 3845 connecting to Cisco 7600 Leased line router.We would like to use ISDN as backup.I have attached the network diagram.Query:1.Referring to diagram, what is the best way to configure interface A&B and C&D.Is it b...

How do you prevent the default route from being injected into EIGRP when you issue the redistribute static command under the eigrp process?

1. ''EIGRP stub connected.''Does this command prevent the router from been a transit router. What about other traffic destined to the router,will they be prevented. 2. does NTP relationship use hello and hold time? How is it altered?3.why is MHSRP pr...

Hello Experts,Need your inputs:I have a Cisco 3825 runnnit IOS version:c3825-spservicesk9-mz.124-12c.binconfigured with Gigabit ethernet 0/1 as the WAN interface. The configs are as follows:class-map match-any Multimedia match ip dscp efclass-map mat...

Our current environment has a 1841 with 2x VWIC 2MFT-T1-D1 modules one has 2 Internet T1s that are bonded via MFR. We are adding a 2 MPLS T1s and want to bond them with MFR on the 2nd 2MFT-T1-D1.The question is, are there any issues to be aware of w...

Hi folks.I'm new to cisco and need your input on a topic. My own research has identified lots of different gadgets out on the market that can do what I want, but I hae heard it is easily possible with a decent Cisco switch.We have an 10MB Internet c...

I have a requirement to configure QoS on an internet link that is limited to 1mbps upload speed. There are remote sites connecting to this HO site that have much larger bandwidth limits so i want to control outbound bandwidth from this site.As an ex...

Hi,Has anyone used the bandwidth estimation feature in IOS?I have a question about the methodology that I'd like clarified, as follows:Basically, what I think happens is that you define a bandwidth (% or whatever) and then define QoS targets (drop, d...

I have a basic question or two about how to connect these two routers. I have one 2600 router and another 3810 voice router. I have router-on-a-stick setup on the 2600 with two IP phones and a switch, and on the 3810 I have two analog and one IP phon...