Routing

Hi all,please i need urgent assistance i cannot ping the K-LEX MGT-IP(10.213.144.3)FROM NMC2-3 (10.201.146.4) & NMC 2-4 (10.201.146.5).included is the diagram and configs for the routers.pls i need help to solve this problem.thanks evr1 and waiting f...

Hi,I am using Multhoming set up and having Internet links from two different ISPs.I have hosted sites and VPN running on these over these two links.Can I somehow control the incoming traffic to my hosted site over a link and dedicate another one to V...

At my location we have a primary and backup internet connection. The backup connection is completely underutilized; no traffic traverses it unless our main connection is down.I'd like to use policy based routing to direct all http traffic across the ...

1. How do I short down ports on a router ?2. Is debug allowed/advisable in a CCIE lab ?3. I have many switches connected,with diff vlans assign to port, is it possible I detect broadcast or loop on any port,on any vlan on any switch

I have two connections between two of our sites, a 100Mb link and a 75Mb link, all routing is done with eigrp and the 75Mb link acts as a backup.Is there anyway to load balance between those two links with EIGRP? I know with equal cost paths it's no...

How does unicast reverse path forwarding work when there is a default route in the FIB?uRPF does a reverse check to make sure that the return sourced traffic can make it back through that same interface otherwise its dropped. Now what happens if its ...

Hi , We have WS-C6509-E with IOS disk0:s72033-advipservicesk9_wan-vz.122-33.SXH.bin" (SUP:VS-S720-10G ) .It has been running for last 25 weeks . But now we are facing an issue in the access-list . we are seeing some junk character...

I have a couple 7206VXR routers (one production and one spare) that are giving me this message when I do a sho flash command. I know the slots work because I powered the spare down, installed another ATA flash disk in slot0, powered up, and was able...

I am trying to configure a Cisco 2600 series router with the ability to respond to ping requests no matter if the devices are online or not. I would like the person performing the ping request to believe that the devices are alive on our end--that ea...

There is something I am not understanding here. See attached for my config on my 1841. I am accessing the internet via bonded T1's using MLPPP. The ISP has assigned me the address block 67.100.220.xxx/29. I have fastethernet0/0 attached to my local (...

We are experiencing occasionally high levels of input drops/receive discards on the 3660 router that connects our central site (300+ nodes) to the internet via a 100MB link. The prevailing consensus has been - it's an old, verging-on-obsolete router ...

Hi Chaps,I have an OSPF area for which I wish to select which external routes enter it. This area has default routes comming from two points, so I cannot make it a stub area as to do so makes the default route injection unconditional, which I don't w...