Hi all, need enlightenment, i try to configure "distribute-list out" to filter rip routing update. the goal is to access one destination(in this case Lopbck1 on router 1) from different source/segment through different link as well. my configuration ...
I have seen other QosS questions, but have some that apply to me that maybe someone can help with.We have Main branch with 9M (X6 T1) that holds call manager and all the voice servers (IPCC, Unity).The 6 remote branches have T1s with 768k CAR from th...
HiI have 8 E1 line to connect another site.I configure multilink and get bandwidth 17 Mbs. but suddenly when 1 e1 is down then total link is down but show multilink is up. i can not ping connect site. when i pull out the faulty e1 then again connecti...
Hello,I was hoping someone could assist with providing me details or perhaps a link where I can find the default configuration settings of the WIC-1DSU-T1-V2. We are trying to determine - the out of the box - default behavior of this module and what...
Hi All, Can anyone check out my config and advise where my VPN Config is going wrong. There are two configs required. A Site to Site and a PC to Site. I am testing the PC to site using VPN Client. If I have no username and password configured in t...
Hi,First Happy new year for 2009.I have a Catalyst 3560-48PS-S in 12.2(46)SE IPBASEK9 IOS and I can't apply a "service policy-map input" on my L2 IP Phone FastEthernet ?This syslog is displayed :%QOSMGR-4-CLASS_NOT_SUPPORTED: Classification is not su...
I have a site running EIGRP that has two possible gateways. Currently, one of the gateways is a 10MB PTP that I want to use as the primary.I have a 1.5 MB PTP that I would like to use as a backup (only if the 10mb fails). Here is my question - I pu...
I have an ASA that can't ping ip addresses that end with an even number. For instance I can ping 4.2.2.3 and 4.2.2.1 but can't ping 4.2.2.2 I've tried with different ip addresses but it's always the same result. Any ideas?
Hey folks - just a quick question to confirm what I already think - I am looking at installing a 2821 with 4 t1's in a multilink group. I am pretty sure I can enable encyrption on the multilink, but wanted to make sure. The other end will be a Cataly...
Hello,For the most part I understand the purpose of clocking. The majority of our circuits are Sprint MPLS and the clocking is derived from the line.What I'm confused about is how to configure clocking on a pair of routers that are connected to each ...
Hi All,I was hoping someone could help me with a load balancing issue I'm having.Brief network setup:Customer has a Point to point serial T1 to our primary datacenter on RTR 2.Customer has a Frame relay -> ATM T1 to our secondary datacenter.Primary d...
