Hi, In past few years, some people were working on developing algorithms and schemes to reducing power consumption of network device. I'm wondering, whether any of the proposed schemes has been realized on any cisco routers/switches? If it does, can ...
sir,I am getting log in cisco router for sub-interface- duplex mismatch discovered on GigabitEthernet0/1.2 (not half duplex), with SEP00170EF9E8B6 Port 1 (half duplex).I must have to set duplex and speed auto in interface gi0/1 for other VLAN.How to ...
Hi,I need vlan loadbalacing in PVST Mode how to do it is there any help ?my senario is 2 core switch , one link from 1 core and 2 link from another core connected to one 4510R distribution switch and from distribution to 2 uplink connected to one acc...
So here is the situationI'm trying to port forward on this router so that anyone who http's to the outside interface on port 8081 get's forwarded to a device on the inside at ip 10.10.10.1 on port 8080 for it's gui.so far what I have is ip nat inside...
I need to replace a 3660, which has 8 fastethernent and 4 serial. I have a 3640 and have found 2 4 port eithernet cards and a 4 port serial card would this work. This is only for a shourt fix. I been told a 3662 may be a better option if so would car...
Hi there,I'm trying to understand the behaviour of class based weighted fair queue (CBWFQ) under particular conditions.Say have 2 queues.Queue 1 - bandwidth 50%queue 2 - is the default queue bandwidth 10%There is no LLQPolicy is applied outbound.For ...
Please look at the attached visio. My question is how does the router with network 10.0.0.0 know about 172.20.0.0 and 172.20.9.0 on the other side since i am only using 172.19.1.0 in EIGRP? the switch 172.19.1.8 knows how to get to those networks.T...
Hi there,My company has some VC equipment connected over a WAN - There are three sites which connect via a mangaged MPLS network.We've had issues with quality and the supplier recommends trying some QOS. My question is where to place the QOS?Each set...
What protocol or product is there that will allow BGP to be optimized based on latency, wan saturation, etc. We have looked at devies like Internaps hardware, and looks interesting. But we want a Cisco solution for our network.
Customer wants a 2 wire LRE solution the will provide them 100 Mb of throughput maximum distance is 2500 ft. I have not been able to locate any devices that supports that type of throughput on a two wire.
Hi,I`m trying to run isis over etherchannel subinterface on an ASR1006 and i`m getting the following error message:CLNS-3-BADPACKET: ISIS: LAN L2 hello, Duplicate system ID detected....Here is my ethernchannel config:interface Port-channel10 no ip ad...
Hi All,In our network we are running MLPPP on major locations. The problem that we are facing is when any one of the E1 bundled in multilink flaps, the multilink got hung. The multilink stays up but we are not able to ping the other end /30 ip. In th...
