Routing

Hi,I have been receiving the below mentioned error frequently on my Cisco Router after the WAN link(Local loop) replacement. I searched and found its a BGP Subcode 6 is described as " Configuration Change". But no idea how to eliminate it or what cou...

Hi,I need to redirect traffic for a specific IP address to another device (for DR testing purposes).There are a handful of wireless AP's that communicate with a controller. The controller is located at another site and connects through a Cisco 2800 ...

Hello, I'm just starting out with my CCNA. Could someone explain to me what the difference is between a Cisco Catalyst switch and just a Cisco switch? I can't seem to find a good answer. Thanks,

I have several business objectives that I would like to accomplish. They are: Business Objectives:#1 Provide redundant many-to-one NAT Internet access from both Edison and Montvale such that the outside source IP address remains in the same Class C...

I have a quick quesiton....on my edge router I NAT both in and out. Coming in I have a NAT pool of 170.132.134.0/24. Also my customer has me NATTing my internal server to a nat block of 169.176.124.0/28. So what I have done to test is on my edge ro...

Hi all,I am trying to configure a Cisco 877 with vpn from sweden to uk, I have configured the router for UK fine, but struggling a bit for Sweden.I understand the do not autheticate using chap so a dialer interface is not required, also they dont see...

3825 running EBGP connects to WAN and IBGP to exchange with 3750.3750 L3 switch has Four VLANs running iBGP192.168.1.1 VLAN 1192.168.2.1 VLAN 2192.168.3.1 VLAN 3192.168.4.1 VLAN 4 Should I have 4 sub interfaces on the router for the 4 VLANS on the sw...

We have a 12 site MPLS network managed by a large provider. We are using BGP on the MPLS side and eigrp internally. We have a ISP in Site 1 and Site 2 and we want to configure our network so all internet traffic goes through Site 1 (except for loca...

Why would I use the HWIC-1DSU-T1 over the WIC-1DSU-T1?

Hi everyone,One of our customers currently has his Data centre in London and is planning to establish another data centre in Amsterdam as a disaster recovery in case something goes wrong with his DC in London. Is there any way to use the same AS numb...

how would be PSTN configuration at branch & head office location: at branch location: we got 1. cisco 1841 router with WIC 2A/S 2. D-Link dfm 562e++ modem 3. v.24 cable that connect router serial & modem. @ head office: 1. AS5350 my boss want config...

I am interested in having a particular VLAN in two separate sites. I have read a little about it and was wondering if it would be possible to do across a point-to-point DS3 connection. I see a command on my serial link "Router2(config-if)#dot1q tun...