Hi,I config a tunnel between HQ and remote office via Internet. The total Internet BW is 10M. I would like to allocate 2M for tunnel. Do I apply the rate limited on tunnel? if so, it will limit the Internet traffic also. Any work aroundrdgs
My network is about 35 nodes(routers) which each one is acting as DHCP server for its network. Which is the best. As it is or a central DHCP server and the remote routers as DHCP agents. Thanks a lot moses
I have a router ( in one AS) that is advertising the routes that it learned from a peer (in another AS) back to that same peer. ( it should only be advertising 11 prefixes that originate within If you look at the output below, the next hop that is b...
I have a pool of ip address one the WAN link which is terminated at PIX. The inside interface of PIX is terminated on the switch. Now i have to add the Router in the network for GRE communication and want to use the one ip address of this pool on the...
guys i am going nuts please help me out ......i have four routers A,b,c,drouter A B and C serials are in same AS XX....router D and C ethernet are in different AS AA.....all routers have loopback interfaces.....redistribution of eigrp is done on c ro...
I've been trying to set up a frame switch for my home lab and would like to know if anyone may be able to help. None of my frame-relay PVCs are active and I'm wondering what I am doing wrong.1) For the frame switch I am using a 2610 with c2600-ik9o3...
Cogent is handing me off a 100 meg circuit and am wondering if my 3550 will handle. I'm told it will but need the IP Services firmware. I currently have an 1841 handling it and I don't know if I getting all of the throughput.
If I create an access-list for my EIGRP distribution list with last line being:access-list 10 permit 0.0.0.0 255.255.255.255Will this allow all EIGRP network advertisements through the filter?Thank you!
Hi, Lab Scenario:R2, R5 & R6 are connected in a Partial Mesh F/R topology with a F/R switch at the centre.R2 is multi-point sub-int whereas R5 & R6 are using physical ints.EIGRP is configured on each router advertising network 150.50.0.0 via 'netwo...
Hi !could you please help me - Is there a limitation of the amount of supported SIP-400 cards in a C7613? I heart, that only 4 cards are supported.thxHans
Giday....we have 2 nets, net a and untrusted net b, currently we have one way nating from net b to net a translating to one net a address.We now have a requirement for some net a addresses to send traffic to around 10 static addresses on net b.This n...
