Routing

We have installed redundant PRP-2 modules in a 12010 chassis and we were under the impression that the Ethernet ports (eth0, eth1 and eth2) could be used for routing purposes.I have found documentation on the older PRP modules which states - " The PR...

Under sh traffic-shape fastEthernet 0/0, the output is Target rate = 640000 (bps), Sustains bits/int = 40000 (bits), Internal 62ms and increment 5000 (bytes). From my understand the total bandwidth allowed on the physical interface is 640Kbps. The ...

HiOn our network we use 6500/4500 and 2851 routers. On some of our connections we have large output drops "Total output drops: x" counter.Does anyone know how often this counter is incremented is it for every drop or say 1 in 100 i.e. is it limited i...

I have mrtg which graphs cisco 10k router traffic input and output on interfaces. It graphs well except on 1 interface (POS). On this interface the input rate on sh int and on the graph don't much. There is around 120M on sh int and around 6 on graph...

Have a scenario where WAAS is being implemented. The challenge we face is this:1. WAAS is being implemented at headoffice and all sites. Each site, including headoffice, have dual routers with dual links into an MPLS environment, and two WAE applian...

Dear experts,i have cisco 1841 router in that Iam trying block some of the sites using NBRbut i am unable to trace out the problem.plz go through the config and plz tell me where i was wrong,sh runBuilding configuration...Current configuration : 1284...

When redistributing protocols into BGP and using the metric command at the end, what value is that metric value. On cisco documenation, it saids its the IGP metric value, but how is that affect BGP? In other words in the decision process for BGP, h...

HI, I took console for 1760Router after booting the router.it's asking system configuration dialog then i gaiven nobut it's not accepting that even yes alsowhat could be the probelm and what are the points i want to check

Hi All, May i kindly solicit any help as to why some books configures EIGRP in a way illustrated herein.A router needs to advertise the following routes: 1.1.1.0/321.1.1.1/321.1.1.2/321.1.1.3/32And this was eventually advertised as Network 1.1....

Dear friends,Need a simple clarification.How to find ospf version running in cisco? ( not google;)or exactly,which command will show you the ospf version , which is running in your router?tnx in advancerajeev.s

except CLIany tool (SNMP or MIB)can monitorCSS Session(Src to Dst)tks a lot

Will GLBP do load balancing between 2 ISPs which are connected to 2 interfaces on the same router?In other words, I have only one router with multiple physical interfaces. Interface0 will be connected to ISP1Interface1 will be connected to ISP2and In...

Our entire office is made up of l2l vpn connections, and now some dmvpn connections. Our branch's are typically a 2811 router with an internet connection back to corp.I understand the limitations to point of QoS and using the Internet. I understand...

Hi,I have a strange issue, whenever the router reboots it loses its configuraiton.I have already done a "Write Memory" but no luck...router is 2800 series with IOS 12.4