Routing

I am a little confused on exactly what this command is doing depending on the routing protocol that I am running. If run in RIP I believe this will clear the routing table and trigger an update. I know that in OSPF this will clear the routing table...

I have a Cisco router and want to achieve the following,1) Source 1.1.1.0 traffic to be NATted to 2.2.2.22) Destination 3.3.3.3 to be NATted to 4.4.4.4Is this possible on a Cisco router-Sai.

Hi All,I have below routeip route A.B.C.D 255.255.255.0 E.F.G.H permanentI would like to modify this route like belowip route A.B.C.D 255.255.255.0 E.F.G.H distance 40Please let me know with out any services interruption. How can i change the above c...

Hi,I am using cisco content engine for caching which is in my central site. I am able to open the vedios from my central sites. But when i try from remote sites its not opening, is there any config required for pointing to the content engine at my ce...

I Have a scenario with a data center that currently only has two layers. The internet layer and distribution swithes.Both the switches and the routers get a full bgp feed. I'm looking to increase the scalablility. I'm looking at putting either a swit...

Can someone explain to me these errors?This is from 2 separate connection attempts, from one PC. It will not connect to my PIX, but I have 2 other PCs at different locations that can connect with no problem. What I am assuming is there is a firewall ...

Hi all, Any one if if i can use virtual to form bgp neighbor ?interface Port-channel1 ip address 192.168.1.2 255.255.255.192 standby 1 ip 192.168.1.1router bgp xyz no synchronization bgp router-id 192.168.1.1

I am currently experiencing congestion on my link to branches, so i will like to apply Qos. My problem is I am using tunnels to the braches from the backhaul, through the ISP cloud to the braches, my proble now is should i apply the qos on physical i...

Hi - I have a wan which is a MPLS cloud. Access to the cloud from the router is for instance a 100M ethernet connection however we pay the provider for say 10M access. I want to ideally shape my outbound traffic to 10M and I don't want any packets to...

HelloI have a 4 networks and I will connect them with OSPF network.I need to know more about redistribution with details and examples.Do you know any book and documents that you can recommend.RegardsErsin

Hi all. I have a pix 515 with 6.3(4) ios. The pix is connected to my office/dmz/internet networks. Due to some sql requirements, the web server on my dmz network is allowed to access my sql server on office network. My web server is using ip 192.168....

Hi,Can anyone help me to resolve this issue.My router Cisco 1751-V taking 10 minutes to boot.Which has 32 KB RAM and 32 MB Flash.Having the following IOS c1700-sv3y-mz.123-2.T.binThanks and Regards,Lavnaholy

s1(BGP) s1 (eirgp) s0(eirgp) e0---->>RouterA<<---------------->>RouterB<<----------I connected one interface BGP and another interface is eirgp, am unable to ping the router Ethernet from routerA after configuring the redistribute bgp 6500...

Hi All,I would like to know which IOS version higher that I listed out below.1. Version 12.3(7)XR32. Version 12.3(2)XC XR3 and XC makes me confused.Thanks,