Routing

I need urgent help with this.ROUTER#test interfaces fa 0/1.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! Failed - timeout problem1 interfaces: 0 passed, 1 failed, 0 skipped, 0 untestableROUTER#tes...

We have two routers, A and B. THey both configure with HSRP so one is active and one is standby. If A down, B will be active. But I need help to configure EIGRP for failover. Let's say if only the circuit on Router A down but not the router, how can ...

I have several remote sites that connect to my central site via a provider MPLS network. These remote sites all use the central site for internet access. I would like to have a couple of these remote sites to use a secondary site for internet access....

I use cisco router 2821. I connect internet by use WIC-1SHDSL-V3 card(G.SHDSL). The connection was success, I can access to any web sites except Microsoft site such as http://www.hotmail.com When I request http://www.hotmail.com, the main page can di...

Hi,I have a situation where I need to have a Disaster Recovery Site with same IP Subnet that is of the main site across a WAN link using Routers.I'm not sure of it now and not able to recall the name of the technology about it.Any help would be great...

I am trying to configure WCCP on my 6513 switch and use my management VLAN as the interface with that particular IP address as the WCCP router IP address(i.e IP Unnumbered) however I am getting his error:DP6513(config)#int lo255DP6513(config-if)#ip u...

Could someone point me i the right direction, on how to route all traffice from (2) VLANS into and out of specific ports on our core router.We are putting a LAN accelerator in between.

Hi,I have a Cisco 7206 Router with 2 FE interface. One for WAN (FA0/1) and LAN(FA0/2) and my WAN is connected to a 10Mbps circuit from the ISP, on my network I'm using NAT. Network TopologyLocation: Philippines ISP's(Modem) ...

Hi all, I have a 2500 router running IOS (C2500-JS-L), Version 12.0(10).It currently uses a T1 or Frame circuit and uses our centralized servers at HQ for dhcp.I want to control dhcp at the router. How can i do that?On my 1750 routers with 12.1.3(x...

HII'm working as a network design engineer for the service provider market, and have to design solutions which in most of the times incorporate 7200, 7300, 7600, GSR ,ASR etc. Does any one know of a good training for this type of platforms. Basically...

Imagine I have Router3825Headquarter connected to MY_MPLS network.Then I have 3 2851 partner offices connected to MY_MPLS network. Servers are located on Headquarters. All sites including headquarter connected via 9Mbps circuit.Management is asking:W...

Hello Netpros,I am trying to choose a router/IOS for our environment. We will need to have a T1 and cable modem (30 megabit max download) both with ethernet hand-off coming into the router. The ability to fail-over/load balance, have maybe 5 incomi...