Routing

Hello,I got an 1841 router and installed a VWIC2-1MFT-T1/E1 card for our incoming PRI. I got the card setup for a T1 but when I try to do the pri-group config I get the following error:%Please configure network-clock-participate wic 0 first%Insuffic...

Hi we have a situation in which we need to be able to terminiate or bundle 8 T1 circuits on a 3845 router. What would be some recommendations? ie what type of cards would be needed, would those cards need to be have built in DSU's?? Any information w...

I have routers that are setup using point to point T1's and static routing. I am coming from a remote location with ip address of 10.101.x.x The DHCP server and other resources are on the 10.150.x.x and the 10.1.x.x networks. The interfaces for the T...

Hi All,I have cisco 2821 connected with an MPLS link which supports two networks (Network A (Data), Network B (Data & Voice))We a new MPLS link willing to terminate on the same router 2821 which will support Network B (Data & Voice)Condition: Network...

We have 7200 VXR NPG1 router, in which two STM links is been terminated, all of a sudden, STM links went down, when coordinated with provider, they have initiated a bi-directional loop, in which we were not able to see the loop at our end for both th...

What cmd would I use to priortize data based on filename? For example, I have one file called HIGH.txt (30mb) and a second file called LOW.txt (30mb). Using NBAR, prority should be given to HIGH.txt before LOW.txt. Below is my command:rotuer(config-c...

We have a branch office connected by a point-to-point T-1. The branch office router will accumulate CRC and Frame errors and various times during the day. It is at this time that users report issues from the site. I have had the SP test and of course...

Have a 3660, that when following the password recovery procedure http://www.cisco.com/en/US/products/hw/routers/ps274/products_password_recovery09186a0080094774.shtml doesn't allow to perform foward of step 10 on the procedure and doesen't allow to r...

Cisco 7206VXR (NPE-G2) processor (revision A) with 917504K/65536K bytes of memory.Processor board ID 26813841MPC7448 CPU at 1666Mhz, Implementation 0, Rev 2.16 slot VXR midplane, Version 2.6Cisco IOS Software, 7200 Software (C7200P-SPSERVICESK9-M), V...

how to configure BGP advertisements through prefix-list in time-based manner,

i have 4 links for a same location, which is in Backbone area.but there is no load balancing

Hi FriendCan anyone tell me what is differeance between L2 VPN and L3 VPN. what are advantage and disadvantage between them, Give me some documents for further study.-V

Hi,I have looked at the router performance PDF to try to discover max throughput with these two routers however, it only talks about raw throughput with no features enabled!Can anyone point me in the right direction as what the actual values would be...

Can someone help me choose a router or a combo of routers to connect 7 remote locations back to my main office using point-to-point T1 circuit. Do I need multiple routers or is there a single router that can do it at my main sight.