Routing

Guys, please confirm if I put a Cisco 1841 to handle a 10Mbps MPLS circuit I will be alright.In addition to the Fastethernet copper MPLS connection, I need to handle (3) FastEthernet connections.

Hi,Can we do internet traffic load sharing/balancing with 2 ISP ?.We have one gig link installed from 1 ISP and 2nd from different ISP, using as backup. we like to do load balance internet traffic, but do we need both link from same ISP ?Regards,

How can i restart the controller t1 after making changes to the clock without reloading router?

Hi all,We are planing to leasing an 45Mbps Frame-relay circuits. Which port adapter can supported on CISCO 7206VXR platform?

dear sir,i have 2600 router in that i want nm-hdv-e1 cord which will support 30 channels.so iam attaching my sh-version plz tell me this router will support or not.cisco 2610 (MPC860) processor (revision 0x00) with 61440K/4096K bytes ofmemory.Process...

Dear Experts,I am getting latency high for the 2Mbps link .Due to this in our telecom sector we are getting Junk values.After some time ie.,10mins Iam getting 11ms.Can you pls suggest what can be doneReply from 172.16.192.1: bytes=32 time=152ms TTL=2...

Hi,In my customer network I have WIC-1ENET card terminated on routers on which L3 VPN links are terminated as primary. Problem is when this primary link goes down the fastethernet interface remains up and backup won't work.Please suggest what is the ...

Hi In Cisco 4500 series switch is it possible to limit bandwidth for Gibagit ethernet port? For example port gi 1/0 should have only 5 Mbps upload and download speed Thanks and RegardsPrabu

Hi All, I have internet access via interface fastEthernet on my router and the other port connected to internal network. If i have the other fastEthernet module insert into my router and 1 adsl connection, Can i configure adsl connection to backup...

I have noticed that we seem to be incrementing memory allocation against the memory allocating-process "CEF: state msg". I cannot find an explination of this statement.Could someone please shed some light as I beleive we have had this before, but a r...

I have just received a new 857w router with the latest IOS 12.4(15)T4.In stead of the old version, this one has introduced zone-based policy firewall.I upgraded the SDM from 2.4 to 2.5 and tried to use the wizard to implement the firewall. But failed...

Can policy-based routing be applied to a tunnel interface? I'm looking through documentation, and I can't find any evidence suggesting that it's not supported.