Routing

hi everyone, i have two enet port on this router fe0/0-10.116.144.1 fe0/1-10.16.144.17. issue is i have a pc1 connected with .5 and pinging the router fe0/0 interface and pc1 was successfull from the router.however for pc2 connected with .21 i could ...

Whenever I attempt to download a video from Itunes the TCP session is dropped somewhere during the transfer. This will happen on any computer connecting using this router.000103: May 2 14:22:29.998 PCTime: %FW-6-DROP_PKT: Dropping tcp session 166.70...

Hi,I would like to know if it is posible to pass multiple values from one eBGP peer to another - i.e. with something similar to extended communities? I.e. can an upstream peer pass 6 variables to the downstream peer for processing and making a route ...

Hi,Can we use cisco 3845 router for meeting the requirement of 45Mbps point to point link.

Hi,Not related to any problem.But just want to know that if i need to know in which Internet Ring i am currently, then how can i find?using trace? then to which ip address?Thanks

Hello friendI have question, i have three router connecte like Lan-R1-R2-R3-Lan.suppose i am doing Qos on R1 router ( like ipprecedance), should i need to Qos or any kind of configuration requied on R2 and R3 router... Please suggest-V

Hello,I have 3600 with 5 adsl ports. I try to config it to connect to the ISP but it doesn't work.my configuration is:ip vrf 6!ip vrf lan rd 100:1 route-target import 200:1 route-target import 300:1 route-target import 400:1 route-target import 500:1...

I have a question concerning a high availability design. We are running OSPF internally, all in the same area. My questions are concerning the etherent connections in violet. In our network, internally, all router ethernet interfaces are in the same ...

I'm kind of stumped so need some advice. My current setup is a pair of T-1s that go into a Cisco 2811 which in turn goes to an ASA 5510 then into our DMZ and our network.We've run into a serious bandwidth issue so are making some serious upgrades so...

I am trying to configure a channelized E1/PRI port on a Cisco 2851, connecting to a E1 (1984kb). Can anyone provide an example or a reference on the configuration? Thanks in advance!

See, they've got this WAN Routing & Switching Forum; as well as a LAN Routing & Switching Forum; and I'm thinkin' if you've just got a general conceptual question about a routing protocol, that isn't dependent on whether the network is a WAN or a bi...

Hello,I'm trying to setup a new branch office with a DSL Modem, Firewall and MPLS connected to a cisco 2801. I have a /29 IP block from my dsl provider. Since the router is going to have one interface to the Modem and another to the firewall, is it p...