Routing

Dear all,for fire the ISDN isdn test call interface PRIint remoteisdnno this isdn CommandSome other router using isdn call int PRINo Remote ISDN noplease tell me why this differance

HiI have about 8 G.shdsl modems. each link has 2Mbps.i can not use MLPPP case all the links terminated on G.shdl module (not serial link) or can not CEF cause my link are 8 not 6!any other solution?

I am trying to set up a 1812 router with 2 internet connections. One is a cable connection with DHCP and the other is DSL with static IP addresses. Neither ISP supports BGP for me.I have looked at this link (http://www.cisco.com/en/US/tech/tk648/tk...

I cannot configure LLQ (priority command on the GE port) for voice traffic.error is shown below:-policy-map voice_internet class internet police cir 150000000 bc 4687500 be 4687500 conform-action transmit exceed-action drop class voice priorit...

I'm hoping that I can get your guys input or perspective on bgp load-balancing appliances. I'm talking about those appliances which claim to work with bgp to offer "smarter" outbound load-balancing. Anybody ever used any of these and can recommend ...

I tried following the info on this page but no use:http://www.cisco.com/en/US/products/sw/secursw/ps5318/products_quick_start09186a0080511c89.html#wp74383the above tutorial instructs to put the pc into DHCP and then open the webpage https://10.10.10....

Want to create vision diagram, We have a lots of different types of cat switches. Does anyone know which web sites I can find the Cisco real visio icons? Please help.

Hi, I am working on a back-to-back frame-relay lab enviroment. I have the routers configured but for some reason I can route between the two interfaces. I am using Wic 1DSU T1 cards. I have tried routing protocols, I can't do frame-relay map, etc ...

Hello,I have made 2 other posts about this issue and haven't gotten any good results back. Please someone help me, I don't think this is that complicated of an issue.I've got a regular house-hold DSL service with the modem set into bridge mode, so i...

Hi,i am trying to configure something i call STATIC PAT HIGH AVAIABILIY.2 wan links are terminated on 2811 router. these are the nat outside interfaces. I have an application server on the private (inside) of my router which needs to be available thr...

Hi Guys, I dont know this is right forum for sach kind of question if not then please tell me where to post this question. I am facing problem with 3745 series router after reload it goes into Rommon mode. I have checked the config register valu...

Hi, my question is can I have multiple actions in policy based routing statement. For example, I would like for the PBR first to NAT a subnet then send it to next hop. Here is my config.route-map WS permit 10match ip address 10set ip next-hop x.x.x.x...