Normally from the supervisor, I can find the card as follows:Mod Slot Ports Module-Type Model Sub Status--- ---- ----- ------------------------- ------------------- --- --------1 1 2 1000BaseX Supervisor WS-X...
Could any one help me on this:0- The usb ports are not been recognized by router after upgrading the ios to 12.14.5t3. Is ther any bug or is ther any command to configure??c870-advipservicesk9-Mz-124.15.t3.bin
Hi All,I am having 1Enet WIC card in 1700 cisco router. I would like to install the same card to 2621 router. Could any one tell me if it is possible or not . thanks a lot
Maybe I should be calling support..but I dont' think this is a level 1 deal.Basically this is a cut and paste from 2 lab 2811's with advanced ip. I don't beleive I have a tunnel established here. Can anyone see anything inherently wrong. This is pret...
Thanks in advanceI want to access my public ip from internal network, but cisco asa firewall drops the packet.Scenario is like followsOne of server is natted to one public IP on Cisco asa firewall.everything is working fine from outsidethe network ,b...
Hi, I am having a 2800 router and one internet connectivity on that,i am having one another 2800 Router. How i can configure the failover for the internet connection. How the physical connectivity is?
hi i have 1841 router whos IOS ver is 12.4(1c).when i power on the router first it start booting then decompress the IOS then it suddenly stop booting at bellow mention point"Port Statistics for unclassified packets is not turned on."please tell me w...
Hi, I have one 3845 with DS3 connection and it works OK. I tried to insert the second DS3 module in it, and the router did not recognized the module. I will use the second module just to link test .Any idea about the solution ?TIA Amaral .
Hi,I've configured 2 routers and using FR in between. Each router advertising its own network and I've activated default bgp dampening on one of the router.The problem is I can't see the dampening process using "debug ip bgp damp", "sh ip bgp sum", "...
Hi,Can anybody send the configuration for converting a Router in to DHCP Server and how to configure the Scopes(for each vlan seprate subnets) in router? Pls help me.Thanks &Regards,Sham
Hello:My compaany has two locations. We have had them connected via ISDN. It has been working for the past 4 years, but all of the sudden (last Friday) the connection went down in the middle of the night. We have been troubleshooting for days with...
