Routing

Hi,I have 2 ASA 5510's in A/P failover using the Management port.I have failover setup for ISP failover Int 0/0 (Outside) PrimaryInt 0/1 (Inside)Int 0/2 (Backup_DSL) BackupFail over is working perfectly in Int 0/0 goes down Int 0/2 comes up and I can...

Hello Guys!First post and really hoping to get some help here! Been trying to get this working for a while and with no luck, here is my setup and config: I just can't seem to ping anything (eg. 4.2.2.2) from inside my router.ISP Provider (PPPoE) - DS...

All,Could anyone with experience in configuring Netflow on a 7600 Sup720 3BXL carying multi-gigabit volumes of traffic provide me with an exact MSFC and PFC flow timer configuration that provide smoothe graphs?After extensive timer tweaking I am stil...

In a certain large facility, I have been asked to provide strong and reliable WAN circuit. I am considering the deployment of a "fiber ring" served via two conduits, one conduit in the North and one conduit in the South of the data center.My question...

We have tried to do policy based routing between 2 7606 with sup720. These 7606 have the vpn modules. We are doing gre tunnels protected by ipsec. We cannot do policy based routing through these tunnels. We succeed when doing between 7206s. Is i...

Hello, hope everyone is well. We just got an ATM DS3 (from ATT) that we are using to provide DSL service and will also be using for Internet access. The DSL part is up and running; no problem. However, none of us have experience setting up the Int...

Can anyone please help?I've got a Cisco 3725 ISDN router.I have two serial connections going to ISDN30 units (BT). I'm UYK based.I've just had BT cancel 50 of the 60 channels as we don't need them any more.But now, I can't ping most of the the remote...

I am running MLPPP throughout my WAN. Most recently I installed a 3845 and I had to turn MLPPP fragmentation off in order to get the circuits to stop dropping packets. I am have read multiple articles on MLPPP fragementation and still do not unders...

Getting "Community string error". Why its occuring on poller from switch.Ver is - flash:/c3750-ipservicesk9-mz.122-40.SE.binDevice is - Cisco WS-C3750-24TS.Some one can help me out. Thanks

I am able to log in to my routers from LAN- However when i vpn, I am unable to get even a response from a branch router. I can log into other routers at different sites. For some reason though, I get no response from the 4 IP addresses configured on...