Routing

Hi,We are having one router connected to two ISPs. We need to load balance betwwen two ISPs. Also our website is published by ISP 1. Obviously , we need that website is available even if link to ISP 1 fails. Then ISP 2 should publish our website....

Is it possible to have 2 different protocols (bgp and eigrp) in the routing table with the same cost and the same destination? (maybe change bgp administrative distance to 170 same as eigrp) If so, how does the router determine which protocol to us...

Hi all,I have two routers connected over a third router that is emulating a frame-relay cloud.I have set up lookback interfaces on the routers and am trying to use RIP to propogate these routes - summarised. ROUTER A has the following lookback interf...

How many NM-8CE1T1-PRI= can I put into 3745 router given this link http://www.cisco.com/en/US/products/hw/modules/ps2797/products_data_sheet0900aecd80710c88.html it's one so can anyone confirm this for me?

Hi, I am looking for advice on configure CAR on my outside router. I will have redundant routers with both two 12 meg pipes out to the internet. I would like to balance both routers and only allow 8 megs to my own dedicated traffic. Does any have goo...

interface Serial0/1 description *** 512k to SFS8131gsp02 (back-to-back) *** bandwidth 256 <<-- pls explain ip address 10.0.0.5 255.255.255.252 ip access-group ACL-SFS8131GSP01-06 in ip nat inside clockrate 512000 <<< - pls explainthanks!

I am having a heck of a time configuring this module and being able to access it and see the port status. I have been on Cisco's website and just having a hard time getting to the right documentation. The router is version 12.4(18) ip base. I have no...

Hello all,, in bgp transit AS for example i have 4 downstreem neighbours and 2 up streem neighbours,in this i am using stm-1 connectiviy to both upstreems.assume that customers are A,B,C,D and upstreems are X and Yin this for example the customer A i...

Hi All,PCI requires SSH access to networking devices. I have following questions regarding to that:1) I have IOS IP image on my cisco routers. I found that I need 3DES support in IOS for SSH, which comes with IP Plus 3DES feature set. So, do I need t...

Can you check if I understand the following config correctly?There are two devices Router-1 and Router-2. Vlan100 is the interesting traffic. Router-1 handles IP routing for the vlan with a subinterface configured. Router-2 has the ATM WAN connection...

in IS-IS what are the differences between single topology and multiple topology mode?