Hello.I have a Cisco 837 and wondered if the DSL FW can be upgraded like the 877's can? Here's it's output.Router#sh dsl int atm0 ATU-R (DS) ATU-C (US)Modem Status: Showtime (DMTDSL_SHOWTIME)DSL Mode: IT...
Hello.I have a Cisco 837 and wondered if the DSL FW can be upgraded like the 877's can? Here's it's output.Router#sh dsl int atm0 ATU-R (DS) ATU-C (US)Modem Status: Showtime (DMTDSL_SHOWTIME)DSL Mode: IT...
I'm seeing underruns. Unfortunately, searches on what causes this exactly tend to turn up people's show controller commands that have 0 errors.M1T-T3 pa: show controller:PAS unit 0, subunit 0, f/w version 3-93, rev ID 0x2800001, version 3idb = 0x200...
Hi,We have recently had a 50Mb ethernet service provisioned between 2 POPS - Latency is approx. 13m/sec.Testing the service, we are only able to achieve ~800K/sec (FTP+HTTP between 2 Linux boxes) in a single session(If we run multiple tests simultane...
A few times a day we can not reach one subnet across one of our WAN links. the traceroutes die at our WAN router before it hits our core router. I cleared the arp table on the 2651XM WAn router and was able to ping. I am not sure if it was by chance ...
Good day I just have a quick question...I have a point to poing frame relay connection and I want to enable fast switching at the distant end. If I do that is there a possibitlity of disconnecting myself from the distant router? Also would I need t...
Hi,I have this setup as attached. I'm thinking if this will work and wondering if the reason that I can't connect to Internet from LAN is because the IP addresses that I assigned to the ADSL modem and the router are private addresses. ASA5505 is dire...
Hello,Whether the EIGRP topology table will have details of all the links in the network? or only details of links connected to its neighbours?In many documents,it is given that ,eigrp topology table will not have all the links in the netwok/AS liste...
I have been asked to make a list of all of the switches and if the ports along with VLAN's are forwarding or blocking. I have been trying the CNA and feel that the information I need is there but I just haven't been able to view it. Any ideas?Thanx,M...
Hi,This is basically a call center setup where all external voice connections will get terminated into edge switches.We need to run iBGP between ASA5540-AIPSSM, 6500 switch having FWSM modules. eBGP will run b/w ISP & the Internet Routers, rest will ...
hi dudes!I have two GSRs as Internet routers in my network which I am intended to connect with two ISPs. I want to have in each router two links directly connected with both providers for BGP redundancy purposes, but due to economical limitations a s...
Hi everyone,I have the question about how the packets that match the access-list and match NAT statement are switched on CEF enabled IOS router. Router is Cisco 7301, Cisco 3825 and Cisco 2811 and all of interfaces are CEF enabled.The access-list doe...
if Cir = 768KBc = 2000Be = 7680what will be Tc?
hi, i have two layer 3 switches and 1 router with two ethernet interfaces.Can i configure redundancy for the router, so that if one switch goes down , other switch will take up the position.Also , is etherchannel is beneficial between switch and rout...
Hi All, Can any one guide me on my following question. I have two 6500 (Sup 720) chassis with FWSM module in each. I need to configure Hot standby mode both in the switch and FWSM module .FWSM will be in multi context mode. In this multi c...
Dear All,I am having 30 branch locations and each branch location is connected to central location with 2 Mbps leased line. At the Hub location is it possible for me to pur 30 Serial to Ethernet converter and connect the links to a L3 switch? I want ...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
04-26-2024 09:18 AM | ||
04-26-2024 07:58 AM | ||
04-24-2024 03:30 PM | ||
04-24-2024 03:57 AM | ||
04-23-2024 05:38 PM |
User | Count |
---|---|
11 | |
9 | |
5 | |
2 | |
2 |