hello guysi want to limit bandwidth per usersmy users make pptp to router, i want specific bandwith for each pptp user.help me with your ideas
hello guysi want to limit bandwidth per usersmy users make pptp to router, i want specific bandwith for each pptp user.help me with your ideas
hi,I have 2 878 routers that will be getting connected via a BT ESP8 4 wire circut, but the carrier detect led will not come on, I have checked with BT and they are saying that they can only see the TX of the routers at both sides.I have had to use a...
I'm going to be getting a Gigaman link from AT&T next week and I'm wondering if there is a module for the 3845 I can get? Do I really need to get a switch to go between the router and gigaman or is there a module?Answers are appreciated.....
cannot connect to 2821 router using SDM tool(web based).please help.
I have an 871 right out of the box. Hooked up a VPN to our corporate site and it seems after a while the outside interface drops the connection to the dynamically assigned adsl connection. Happens within hours and somtimes minutes of no traffic. Relo...
I am having some problems with Stateful NAT. The translation works OK at the primary, but the NAT table at the backup seems to have mangled the session information. Has anyone else seen this? I am using 12.2(15)T17.(Oh I wish we could use the code...
Hi all. I have a question regarding debalancing of the two equal uplinks within the same AS. I have two routers that have BGP established between them. Although we are couple of hundreds of miles away, we do belong to the same autonomous system. We h...
Hai all,One of my customer is facing the issue in IPLC (Ind to US ) ..india end its E1 ..were Us end is T1 ...Customer dont want to club 2 T1 to give E1 Output at US end ..Is this setup possible ..if so what shud be the config at both router ..Thanks...
Hello,I'm looking for a way to redistribute a route to a device reachable via a dialer interface during the time the remote side is connected - mainly when the remote side has dialed in, the other case would be nice, but is not necessary.The underlyi...
Hi,How frame relay router gets clocking.clock rate or csu/dsu?.thanks
Hi Experts,I faced with the problem after ipsec configuration. Attached is the debug crypto message for ipsec,isakmp and engine. Hope able to get some lights from you guys.Thanks.
Hi folks,We have the following network,replace loctn with routers. HSRPloctn1 -----------loctn2 | | | | | | | | | | | |loctn3 ---loctn4---...
what is the major advantage of using MPLS in place of Frame-Relay in a Network.Technically as well as Economically.
Hi, from the attached diagram, why i cannot ping from router A to router C? and vice versa. Router B and C can ping to each other connected and configured for frame_relay using serial cables back-to-back. Router E is configured as frame_switch. What ...
What is the best way to connect two networks which are about half a mile apart and connected by a 12 pair telephone line?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
04-26-2024 09:18 AM | ||
04-26-2024 07:58 AM | ||
04-26-2024 05:26 AM | ||
04-24-2024 03:30 PM | ||
04-24-2024 03:57 AM |
User | Count |
---|---|
11 | |
9 | |
5 | |
2 | |
2 |