Routing

Dear all,I am doing some bgp lab practise, once i finished the bgp configuaration on one router, observe there is one additional bgp route appear in the routing table. Could you give some idea why that happened? Thank you.Vail#sh ip roCodes: C - conn...

Hi All, We have 7206 which has bad Multi-channel T1/PRI card with 4ports. Can this be hotswappable with new part or need to power down 7206..? Please advise.Thank you in advance.MS

We have 2651XM with 12.4(5b) OS, two V2 WICs (W0 and W1) and two FEs. I haven't done much with the Cisco IOS and WICs. I can execute very basic commands (i.e, show run, show start, enable, config t, etc). But I am new to WIC configurations. We are ...

Hi,I have configured nat-pt for communication between ip v4 and v6 communication.From v4 machines I can ping the v6 machines and vice versa.But I can't ping from the both machine at the same time. I am getting drop from one side.Any solution for this...

In a hub and spoke network in order to migrate from RIP to EIGRP, i configure to run both protocols with EIGRP distance 170. Is that a problem?Can this might cause any problems?What shall i do to face those problems?Thanks moses

Customer is considering using BGP to resolve EIGRP routing issues. I say they are better served in tune EIGRP by using stub routing, manual route summarazation, etc. Their idea is to create multiple AS and use BGP between them. This will only min...

I need to combine two VLANS into one.What is Cisco's recommendation regarding the use of subinterfaces or secondary interfaces in the same VLAN ?Is one better than the other for any particular reason ?Any implications regarding HSRP ?

I have three T1 WIC cards that I am trying to use in my 3845 router. I have done some reading and the only thing I can guess is, I have to have the V2 version of this card to work in this chassis? Please advise.

Hi, I have the following topology in my lab setup. I am using xxxx routers, not cisco devices.30.30.30.0/24-|R1| - 10.10.10.0/24 - |R2| - configured RIP between R1 and R2. - Added few static routes in R1 like "20.20.20.0/24 via 10.10.10.10" wher...

Hello, I need to allow PASSV FTP to outside world so users using internet explorer web browser can access our ftp site. What command do I do (use) and show example how to enter command...? Here is what I've done thus far: *** 9.8.7.6.5 is example...

It is my understanding that if packets are CEF switched, they will not need to used the public buffer pool on the router, unless the packet is punted. Only fast and process switched packets, is this correct?

Please see the attachment.Thanksmoses

Hi All,I am the new one here. Anybody advice me to buy a cisco router which is suitable to divide one LAN into two broadcast domains?Thanks,MTK

Hi, I have only ever configured 1841's and 800 series ADSL routers before. We could be getting a 10mb lease line for an office and I was wondering:1.) Would a 1841 (non ADSL version) be good enough?2.) Regarding the config, would it be a lot differe...