Routing

Hi,We have 100mbps trunk link between two of our data centers through a local service provider. We have configured the switch port on both the ends with a dot1q trunk, but VTP information is not being shared. When I run "sh cdp neigh" the switches do...

I have a 871W connecting to a cable modem getting public address information via DHCP, I have added a DSL connection using a Westell router/modem connecting to one of the switchports on the 871W. What is the best way to configure automatic failover f...

a site to site vpn was set up between 871 and 2851. 2821 has a AIM-VPN/SSL-2On 871:sh crypto engine brief crypto engine name: Virtual Private Network (VPN) Module crypto engine type: hardware State: Enabled ...

My router: Cisco 1841 with 2 SHDSL modulesMy requirement:Route all traffic from ATM 0/0/0 to FastEthernet 0/0Route all traffic from ATM 0/1/0 to FastEthernet 0/1The 2 ATM interfaces are 4 wire point to point links.There are 2 /29 subnets to route, on...

Anyone seen config assistance docs for back-to-back Cisco 2811's (simulated WAN w/ cross-over cable attached to Fa0/1) when using the network modules' access ports on each router, on common VLAN, to communicate across the WAN? (Cisco's one config exa...

Could someone please describe the output of this command?I have GEIP and some serial interfaces? which interface use cbus? how can i check it? Router# sh controllers cbus utilization full CY0Bus utilization for five seconds: 13%; one minute: 13%; fiv...

1 what is the CB shapping defaults values more specifically where ?=? belong ( rate <=320kbps or rate >= 320kbps)as in 2 books I find different version( I hope u don?t have to get the router and perform the test)In cisco QOS exam cert Guide by Wendel...

Hello,I'm having problem getting the port forwarding to work. When testing my home router (851w) at work, using VNC, Telnet, SSH, nothing gets through. Cannot connect, so it's not an authentication issue, as I don't reach the username/password stag...

Hi, when you're looking at interface stats for any serial or ethernet interface, and the interface keeps the count of ingoing & outgoing packets... are packets generated by the router itself - eg snmp & lmi - counted in the outgoing packet count?Than...

Hello all, my name is Bernardo, and I'm a newbie to the Cisco world. I have been tasked with connecting our DR location with our Primary location over a WAN. Currently, the two locations are connected via a metro-e.I have two routers available to g...

Gentleman,I have the following scenario:PtoP link between main site and branch.(2620 and 1721 routers)two ASA at each site and IPSEC tunnel.Each site has its own internet access and would like to be able to route internet traffic if the main site or ...

I have Network ISP->Router 1811-> ASA 5505->WorkStationI want have access to internet with public ip serves on work station. Help me debug configs on router and firewall.Config router:interface FastEthernet0 description $ES_WAN$$FW_OUTSIDE$ ip addres...

Router Cisco 1750 supports WIC-4ESW interface?Router: CISCO 1750IOS : c1700-k9sy-mz.122-12