Routing

Hi All,I have AS5350XM-2E1. After reload, when i type command "priv" and "cookies" in ROMMOM - i can see/change data in EEPROM on main board.How I can access from ROMMON to see/change data in EEPROM in daughter CARD inserted in slot 1,2,3. example as...

Are IP blocks assigned to ISP's with any kind of logic? More specifically, if I looked at 209.x.x.x could I tell which State or Geographical area that block belongs to?Thanks

I have a Cisco 7200 with has multiple interfaces. I use services such as Yipes, that set up basically a direct connection to the remote site (usual on a private ip space). My only issue is that most of the services we connect to require us to use NAT...

Hi ,2 questions :1.Is HSRP supported on an 1800 series router , if so which one???Has anyone practically tested it???Does it work fine????2. On a 2800 which card should I go for if I need a Channelised E1 connection???Can I have it on a 2811 ??? If s...

Hi sir, i am going to confgure an EIGRP routing protocol based on my WAN connection i had two point to point connection going to same destination, this two point to point lines is located in same building and it is directed toward the same destinatio...

Hi, I have Cisco 877s all over Australia connected to ADSL2+. All are running IOS version c870-advipservicesk9-mz.124-4.T7 and firmware version 3.010. The issue is that they will be running at around 22mb/1mb for a few weeks then for some reason they...

Hi guys, I have a client who has 8 branch offices.. and all are connected using leased lines. He needs to terminate all 8 connections to the Head office, is there any router that can support upto 8 - 10 WAN ports ? your suggestions would be very well...

Hello all,Is there any tools which can be used to monitor traffic on a T1 WAN link? For example, what programs and services are causing the most data traffic, are there any large data transfers taking place on the line (if so, what is the source and ...

HI Friends,Is there any command to give shutdown to the router and switch apart from power switch.Regards,max

I have a cisco 2500 connected to a linksys router. I have no problems connecting to 2500 from other computers on my local network. I also have port forwarding set in my linksys router, but when I try to connect to the 2500 from outside the local ne...

EIGRP is the hybrid routing protocol right so we can classify it in both the class distance vector and link state is that right?

C 2651.If I want to see whether a "slot" is available in the router to let me add a new module there, which is the IOS command? Cisco works is not working to retrieve this info. I did 'show contr' but that didn't help me.