Routing

hi. which route the dampening process will suppress? is the route in the internal AS it self or route that exists in another AS that transit via our AS? would u please give a condition in the internet that flapping happen that bgp dampening helps......

hi just a quick question guys....if i want to configure VRF....what r the benifits i mena my understanding is its like seprating the traffic at layer three as Vlans does at layer 2....am i right ?? or there is a good answer as i m bit confuse....seco...

hello. could we implement data compression on ppp point-point E1? how to do that? will cef still perform? tx :)

hello guys.. what is the difference auto summary and aggreate address? as i know we can achive summarization with the use of routemap out direction by also create static route pointing to null0.

Hi:I'm trying to set a nat translation from outside to inside for a udp range port.I've try some configurations. Here is the last one:ip nat inside source route-map RTP interface Dialer0 [reversible] overloadaccess-list 110 remark Nat Host RTPaccess-...

I have two ADSL connections to one ISP both running on two different routers, can I configure PPP multilink on them for loadbalancing using one cisco router with 2 ADSL WIC card.

Checked the first few pages of topics and didn't quite see this question. I have an existing 3745 with 1 PRI connection (23b+d) into a NM-HDV2-T1/E1 card. We are in the process of purchasing a 2821 router with a VWIC2-1MFT-T1/E1. I am not planning...

I was wondering how a core switch would feed VLANs to a remote router through other routers. For example, if someone is using DSL on a DSLAM using Vlan 2, which from the DSLAM is connecting to Router A, Router A is then connected via Serial to Route...

Hi,what is the maximum number of EBGP sessions supported on 18xx, 28xx and 38xx routers?RegardsStefano

When do we need to design ospf into multi area ? Any guildline ?

Hi,We are looking for a soluation for a connectivity of PC with simple PSTN moddem to router PRI. Line. This setup is similar to that of ISP who supports dialup connections to internet users. Any link on Cisco.com is highly appreciable. First we are ...

One of our users is getting 4 bonded T1's to the internet. They have an existing 1841 that I want to put 2 VWIC2-2MFT-T1's in... is that nuts? Will the 1841 support this much bandwidth? The router will be doing nothing but passing packets...no fir...

I am trying to configure a MLPPP connection using 2 VWIC2-2MFT-G703 cards. The connection comes up and runs fine but bounces every few days or so. It loks to me like there may be a clocking issue. Does the VWIC2-2MFT-G703 cards support a clock source...