Which are the technices are used to identify the traffice as per source and destination address or port based?how can we differenciate traffic on the base of source and destination address?
Which are the technices are used to identify the traffice as per source and destination address or port based?how can we differenciate traffic on the base of source and destination address?
I need to set up a cisco 1720 router with a vwicmft-e1-d1 to support data only on an E1 line. Where can I find documentation to help me in this setup
Hi,I need some light about the "show ip bgp" output in one of my router.RT2# show ip bgpBGP table version is 2, local router ID is 192.168.0.253Status codes: s suppressed, d damped, h history, * valid, > best, i - internal, r RIB-failure...
Hello,Does anybody had a problem with bandwidth parameter change after reaload?I have a Cisco 877 router with AdvIPSer software and such a configuration considering ATM interface:interface ATM0 bandwidth 256 no ip address load-interval 30 no atm ilmi...
Hello,I need to write a config for a 3825 with a NME-16ES-1G-P installed. I want to use bothe Gig interface on the router to connect to 2 core switches with a BVI interface, as show:interface GigabitEthernet0/0 no ip address duplex full speed 100 me...
Hi All ;What is the best ATM traffic shaping which give the high line BW utilization ?cbr , vrb-nrt ,ubr ?Thx
which solution will be cost effective when i am going to use the T1/E1 line with FR::: Transperent mode or Translation Mode???
Tried to activate the Gigabit port on a Catalyst 2950 series. Can not seem to get the port light to come on.Ran all the commands and the OS appeared to be okay.Changed out the GBIC 1000 LX and that worked.Connected to a known good port on a 6500 sti...
Hi guys i have a cisco 2811....if i want to check which dsp is installed or wherether dsp is instaled (PVDM) which command shd i use to check it.....regards
Dear all,We need to packet capture on the "Frame-Relay" interface, the FR is terminated onto the router with a VWIC-1MFT-E1 so additional hardware will be needed to packet capture?. Could any one suggest me the solution.Swamy
Need my branches client to get dhcp address from the HQ DHCP server. How do i configure that?Branches switch |Branches router |HQ router (connected to VLAN 200) |HQ Core switch |HQ DHCP server (connected to VLAN 100)Other than...
iam working with a OSPF back bone network in that some of the customers are having tunnels thru it what is advantage of tunnels thru the network.
while iam typing the " sh int desc " command some interfaces are sowing as Mu and some others are Mf what is the difference between these two types...???
hi friend,where can i find information and some configuration example for this advanced integrated module on 2811 with spservices? thanks
Hi,I have 512Kbps leased line and pool of fixed IPs for my hosting center,subscribing for BRI or PRI backup line needs any IP address assignment chnages to my servers?. Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
04-26-2024 09:18 AM | ||
04-26-2024 07:58 AM | ||
04-24-2024 03:30 PM | ||
04-24-2024 03:57 AM | ||
04-23-2024 05:38 PM |
User | Count |
---|---|
11 | |
9 | |
5 | |
2 | |
2 |